Abstract:Substitution of Zn with Mg has been reported to suppress CuZn defects, which can improve the photoelectric performance of Cu2ZnSn(S,Se)4 (CZTSSe) photovoltaic devices. In our work, the electrical property enhancement of an absorbing layer can be found by incorporating Mg content into the as-prepared precursor solution, forming an alloyed Cu2MgxZn1-xSn(S,Se)4 (CMZTSSe) phase and increasing the photoelectric performance of devices. By adjusting the doping ratio of Mg, we systemically study the impact of Mg content on the crystal structure, thickness, and electrical properties of the Cu2MgxZn1-xSn(S,Se)4 absorbing layer. Also, the photoelectric performance of Cu2MgxZn1-xSn(S,Se)4 solar cells have a large improvement, and the optimal photoelectric conversion efficiency (PCE) of 7.76% for devices is obtained. Our results offer the finding that Mg doping can optimize the electrical properties of Cu2ZnSn(S,Se)4 photovoltaic devices.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsaem.0c02121?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsaem.0c02121</a>.ICP-OES results of Cu2MgxZn1-xSn(S,Se)4 thin films, XPS spectra of Cu2Mg0.0714Zn0.9286Sn(S,Se)4 thin films, Raman spectra, surface roughness values, average surface current values, I–V curves, and diffuse reflection spectra of Cu2MgxZn1-xSn(S,Se)4 thin films (<a class="ext-link" href="/doi/suppl/10.1021/acsaem.0c02121/suppl_file/ae0c02121_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Synergistic effect of Mn on bandgap fluctuations and surface electrical characteristics in Ag-based Cu 2 ZnSn(S,Se) 4 solar cells

Formation of Alloyed Cu2Cox Zn1-x Sn(S,Se)4 Absorption Layer and Its Application in Solar Cells

Formation of Alloyed Cu2CoxZn1-xSn(S,Se)4 Absorption Layer and Its Application in Solar Cells.

Synergistic Effect of Ag, Sb Dual‐Cation Substitution on Cu2ZnSn (S, Se)4 High‐Efficiency Solar Cells

Boost the efficiency of Cu2ZnSn(S,Se)4 solar cell by using Mn2+ induced ultra‐thin CdS buffer layer

Substitution of Ag for Cu in Cu2ZnSn(S,Se)4: Toward Wide Band Gap Absorbers with Low Antisite Defects for Thin Film Solar Cells

Boosting the Electrical Properties of Cu 2 ZnSn(S,Se) 4 Solar Cells via Low Amounts of Mg Substituting Zn

Strategy for Performance Enhancement of Cd1-XZnXTe/CdS Core/shell Quantum Dot Sensitized Solar Cells Through Band Adjustment

Analyzing the synergistic effect of Ag and Ge co-incorporation on Cu2ZnSnSe4 thin-film solar cells

The Design of Mn2+&Co2+ Co-Doped CdTe Quantum Dot Sensitized Solar Cells with Much Higher Efficiency.

Surprising Efficiency Enhancement of Cu 2 ZnSn(S,Se) 4 Solar Cells with Abnormal Zn/Sn Ratios

Tuning Band Alignment at Grain Boundaries for Efficiency Enhancement in Cu 2 ZnSnS 4 Solar Cells

Synergetic Effects of Zn Alloying and Defect Engineering on Improving the CdS Buffer Layer of Cu2ZnSnS4 Solar Cells

Silver-assisted Optimization of Band Gap Gradient Structure of Cu(In,Ga)Se2 Solar Cells Via SCAPS

Enhancement of power conversion efficiency of Ag-substituted Cu2ZnSn(S,Se)4 solar cells via tuning Cu2+/(Cu++Cu2+) percentage in precursor solution

Doping Behavior of Zn in CdS and Its Effect on the Power Conversion Efficiency of the Cu2ZnSn(S, Se)4 Solar Cell

Optimizing the properties of Cu2ZnSn(S,Se)4 solar cells via cationic substitution with trace Ca

Passivating SnZn Defect and Optimizing Energy Level Alignment via Organic Silicon Salt Incorporation toward Efficient Solution‐Processed CZTSSe Solar Cells

Multinary Alloying Suppresses Defect Formation in Emerging Inorganic Solar Cells

CdS(In)/CZTSSe bandgap alignment engineering for performance enhancement of solar cells without ZnO layer

Effect of sodium doping on crystal growth and band matching of the heterojunction in flexible CZTS solar cells