Abstract:Control of low-concentration pollutants from a semiconductor process vent stream using a wet-scrubbing technique is a challenging task to meet Taiwan environmental emission standards. An efficient wet-scrubber is designed on a pilot scale and tested to control low concentration acid and base waste-gas emission. The scrubber system consisted of two columns, i.e., a fine spray column [cutoff diameter (based on volume), Dv(50) = 15.63 microm; Sauter mean diameter (SMD) = 7.62 microm], which is especially efficient for NH3 removal as the pH of the spraying liquid is approximately 7 followed by a packed column with a scrubbing liquid pH approximately 9.0 mainly for acids removal. It is observed that use of the surfactants in low concentration about 10(-4) M and 10(-7) M in the spray liquid and in the scrubbing liquid, respectively, remarkably enhances the removal efficiency of the system. A traditional packed column (without the spray column and the surfactant) showed that the removal efficiencies of NH3, HF, and HCl for the inlet concentration range 0.2 to 3 ppm were (n = 5) 22.6+/-3.4%, 43.4+/-5.5%, and 40.4+/-7.4%, respectively. The overall efficiencies of the proposed system (the spray column and the packed column) in the presence of the surfactant in the spray liquid and in the scrubbing liquid forthese three species were found to increase significantly (n = 5) from 60.3+/-3.6 to 82.8+/-6.8%, 59.1+/-2.7 to 83.4+/-4.2%, and 56.2+/-7.3 to 81.0+/-6.7%, respectively. In this work, development of charge on the gas-liquid interface due to the surfactants has been measured and discussed. It is concluded that the presence of charge on the gas-liquid interface is the responsible factor for enhancement of the removal efficiency (mass-transfer in liquid phase). The effects of the type of surfactants, their chain length, concentration in liquid, etc. on the removal efficiency are discussed. Since the pilot tests were performed under the operating conditions similar to most of the wet-scrubbers operated in semiconductors manufacturing facilities for inorganic pollutants, this study can be applied to modify the existing wet-scrubbers to enhance the removal efficiencies, especially for low-concentration pollutants.

Experimental and numerical investigation of aerosol penetration through submerged gravel bed scrubber

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

Integrated Gas and Solid Model to Determine the Flow Performance in the SCR Reactor

Numerical Simulation of Semi-Dry Flue Gas Desulfurization Process in the Powder-Particle Spouted Bed

Semi-dry flue gas desulphurization in spray towers: a critical review of applicable models for computational fluid dynamics analysis

Numerical Simulation of Multiphase Flow and Collision Humidification in the Multifluid Alkaline Spray Generator for a Novel Semidry Flue Gas Desulfurization System

Numerical Simulation of Moderate Temperature Desulfurization in Circulating Fluidized Bed Reactor Considering Sorbent Abrasion

Modeling Study on the Impaction and Humidification Process in Desulfurization Activation Reactor

Optimization of effecting parameters for flue gas desulfurization in a self‐priming venturi scrubber using response surface methodology

Reduction of environmental chemicals, toxicity and particulate matter in wet scrubber device to achieve zero emissions

CFD simulation and optimization of flow field and SO2 absorption in impinging stream scrubber

CFD Simulation with Enhancement Factor of Sulfur Dioxide Absorption in the Spray Scrubber

Numerical and Experimental Investigations on Reducing Particle Accumulation for SCR-deNOx Facilities

Modelling of absorption process by seawater droplets for flue gas desulfurization application

Mathematical modelling of a semi-dry SO 2 scrubber based on a Lagrangian-Eulerian approach

Eulerian–Eulerian Numerical Study of the Flue Gas Desulfurization Process in a Semidry Spouted Bed Reactor

Efficient control system for low-concentration inorganic gases from a process vent stream: application of surfactants in spray and packed columns

CFD simulation of chemical reaction between sulfur dioxide and water in a venturi scrubber

Experimental Study on Aerosol Removal Effected by Spray Characterization

Transport Hydrodynamics of Particles in a Gas–solid Cyclone Reactor Using a Dense Discrete Phase Model and a Particle Size Segmentation Method

Mass transfer process intensification for SO2 absorption in a commercial-scale wet flue gas desulfurization scrubber