Abstract:An attempt has been made in this investigation to assess the contribution of various parameters towards governing the abrasive wear response of a zinc-based alloy under the conditions of varying applied loads and sliding distances. The factors whose contribution has been examined include deterioration in the cutting efficiency of the abrasive medium, role played by the SiC particles (dispersed in the alloy matrix) in terms of their degradation and resistance offered by them against the destructive action of the abrasive, subsurface hardening of the matrix and such other related aspects. Four types of abrasion tests were conducted on the samples to achieve the goal. The (abrasion) tests involved the use of (i) fresh as well as preworn surfaces of the samples and (ii) fresh and degraded abrasive media in four different combinations.The study suggests that the mentioned factors contribute to a varying degree towards controlling the (high-stress) abrasive wear behaviour of the specimens. However, degradation in the cutting efficiency of the abrasive medium (through capping, clogging, attrition and shelling) dominates over the influence of other parameters such as abrasion induced subsurface hardening of the matrix. Reinforcement of the SiC particles in the alloy matrix offered improved wear resistance (inverse of wear rate) under less severe conditions such as at low applied loads, wherein the dispersoid (SiC) particles could be retained by the matrix due to low cutting depths made by the abrasive particles. The dispersoid particles deteriorated the wear response of the matrix under more severe conditions of abrasion, such as at high loads, because of larger cutting depths causing fracturing and partial removal of the reinforcement (SiC) particles. The observed wear response of the samples has further been substantiated through the characteristics of wear surfaces, debris particles and abrasive medium after testing the matrix alloy and composite in a typical test condition expected to affect the abrasive medium and test specimens to the largest extent.

A comparison of the erosive wear performance of particle reinforced aluminum matrix composites

Effect of impingement angle and impact velocity on slurry erosive wear behaviour of particulate reinforced aluminium composites

Corrosive Wear of Alumina Particles Reinforced Al–Si Alloy Composites

Erosion behavior of Al–SiC and Al–WC MMCs via powder metallurgy under solid particle impingement

Wear performance of alumina-based ceramics - a review of the influence of microstructure on erosive wear

Study of Wear Behavior on AA6061 Reinforced with Hybrid Ceramic Composites through Optimization

Effect of B4C and SiC nanoparticle reinforcement on the wear behavior and surface structure of aluminum (Al6063-T6) matrix composite

Erosive Wear Performance and Mechanism of Engineering Ceramic Materials

Interfacial characterization and erosive wear performance of zirconia toughened alumina ceramics particles reinforced high chromium white cast irons composites

Tribological behavior of aluminum matrix composites reinforced with ceramic particulates in dry sliding against a semimetallic friction material

Abrasive wear behavior of SiC particulate reinforced AA5052 metal matrix composite

PHYSICO-TRIBOLOGICAL ANND WEAR MECHANISM CHARACTERISTICS OF HYBRID REINFFORCED Al6063 MATRIX COMPOSITES

Study on the erosive wear behavior of Al2O3 ceramics

Erosion-Wear Property of α-Al2O3 Structure Ceramics with Different Experiment Parameters

Wear and abrasion of cast Al-Alumina particle composites

Influence of the Reinforcement Phase Composition on the Structure and Abrasive Wear Resistance of Aluminum Matrix Composites Reinforced with B4C and SiC

Abrasive wear characteristics of a zinc-based alloy and zinc-alloy/SiC composite

Effect of in situ TiC reinforcement and applied load on the high-stress abrasive wear behaviour of zinc–aluminum alloy

Effect of reinforced aluminium alloy LM30 with pure ceramic particles to evaluate hardness and wear properties

Microstructure and Wear Behaviour of Ceramic Particles Strengthening Nial Based Composite

Effect of Different Abrasive Particle Hardness on the Erosion Resistant Performance of α-Al<sub>2</sub>O<sub>3</sub> Ceramics