Abstract:The DPF regeneration is crucial for reducing backpressure, minimizing negative impacts on engine power and fuel economy, but the changes in particulate emission characteristics it brings are worth studying. In this study, the influence of DPFs with different soot loadings on exhaust back pressure and particle emission characteristics, as well as the particle number emission, particle size distribution, and thermal field distribution characteristics during regeneration was investigated based on engine bench test. Results reveal that the exhaust back pressure increases linearly with the engine speed, as well as the soot loading. The increase of DPF soot loading leads to a considerable increase in the reduction efficiency of particle number (PN) and particulate matter emissions, especially for the accumulation mode particles. Moreover, the performance in reducing nucleation mode particles is markedly better than that of accumulation mode ones, and this effect is greatly influenced by the engine operating conditions. At the beginning of DPF regeneration, the PN concentration increases sharply, especially the nucleation mode particles. After regeneration, the PN emissions decrease by two orders of magnitude. During regeneration, the particle size distribution exhibits a unimodal distribution, with the peak value increasing considerably and shifting toward smaller particle sizes. After regeneration, the particle size of the PN peak value slightly decreases and markedly shifts toward larger sizes, the accumulation mode particle concentration increases by 7.2 times, and the nucleation mode particle concentration increases by 2.6 times. Before the DPF regeneration, the axial temperature gradually decreases along the direction of the airflow, and the radial temperature gradually decreases from the center to the edge. During regeneration, the highest temperature occurs in the center of the DPF cross-section, whereas the temperature peak at the outlet interface occurs at the middle position of the DPF. The findings of this paper can provide scientific references to formulation and optimization of DPF regeneration strategies.

Evolution of particulate matter deposited in the DPF channel during low-temperature regeneration by non-thermal plasma

Effect of Temperature-controlled conditions on the decomposition of particulate matter deposited in the diesel particulate filter channel by treatment with Non-thermal plasma

Effect of non-thermal plasma injection flow rate on diesel particulate filter regeneration at room temperature

Study on the Evolution of Physicochemical Properties of Carbon Black at Different Regeneration Stages of Diesel Particulate Filters Regenerated by Non-Thermal Plasma

Non-thermal lasma assisted incineration of particulate matter

Investigation of the Physicochemical Properties of Soot Subjected to Non-Catalytic and CeO2-catalytic Aging under Sequential Aerobic and Anaerobic Exhaust-Like Conditions Simulating the Transition from Engine Operation to Cessation

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution

Effect of Reaction Temperature on the Degradation and Oxidation Behavior of Particulate Matter by Nonthermal Plasma

An experimental investigation of particulate emission characteristics of catalytic diesel particulate filters during passive regeneration

Effect of ash on temperature and particulate emission characteristics of diesel particulate filter during active regeneration

The effect of nonthermal plasma on the oxidation and removal of particulate matter under different diesel engine loads

Effect of nonthermal plasma with different ozone concentrations on the oxidation and removal of different components in particulate matter

Study on regenerative exothermic process in ash containing DPF structure based on lattice Boltzmann method

Full course evolution characteristics of DPF active regeneration under different inlet HC concentrations

Degradation of particulate matter utilizing non-thermal plasma: Evolution laws of morphological micro-nanostructure and elemental occurrence state

Diesel particulate filter regeneration mechanism of modern automobile engines and methods of reducing PM emissions: a review

Numerical Simulation of Diesel Particulate Filter Regeneration Considering Ash Deposit

Effect of regeneration method and ash deposition on diesel particulate filter performance: a review

Experimental Investigation on the DPF High-Temperature Filtration Performance under Different Particle Loadings and Particle Deposition Distributions

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines.

Temperature characteristics of silicon carbide particulate filter during drop-to-idle regeneration applied to a diesel vehicle