Abstract:The regeneration effect of the diesel particulate filter (DPF) under steady-state and dynamically controlled reaction temperature (≤200C) was compared using a home-designed non-thermal plasma (NTP) injection system. The particle sediments and corresponding DPF channel wall were sampled as a whole, in order to analyze the evolution of the micromorphology, lattice structure and oxidation characteristics of particulate matter (PM) at the DPF regeneration interface more accurately. The results showed that after NTP treatment, the degree of aggregation of PM, the transition to a chain structure, and the diameter of primary carbon particles all decreased. The microcrystalline length L a distribution converged in a short crystalline (≤1.00 nm) interval, and the proportion of small microcrystalline layer spacing D s (≤0.45 nm) increased. With the deepening of oxidation, the characteristic temperature parameters of elemental carbon (EC), the light off temperature T s , burnout temperature T e and maximum temperature T max tended to shift to a lower temperature, and lattice defects, number of active sites, and PM oxidation activity increased. Dynamic control of the reaction temperature in the range of 127 ∼ 142 °C can promote the oxidative decomposition of PM, which is conducive to improving the regeneration efficiency of the DPF. The process of NTP degradation of PM consists of three stages, namely the outer shell, inner shell and core oxidation, and carbon microcrystals are exhausted in the iterative process of irregular and regular structure, which is essentially a process of continuously removing carbon atoms in the form of CO x .

The effect of nonthermal plasma on the oxidation and removal of particulate matter under different diesel engine loads

Effect of nonthermal plasma with different ozone concentrations on the oxidation and removal of different components in particulate matter

Non-thermal lasma assisted incineration of particulate matter

Effect of Reaction Temperature on the Degradation and Oxidation Behavior of Particulate Matter by Nonthermal Plasma

Experimental Study of Effects of Non-Thermal Plasma on Exhaust PM Quantity and Mass in Diesel Engine

An investigation of the treatment of particulate matter from gasoline engine exhaust using non-thermal plasma

Effect of Temperature-controlled conditions on the decomposition of particulate matter deposited in the diesel particulate filter channel by treatment with Non-thermal plasma

Effect of non-thermal plasma injection flow rate on diesel particulate filter regeneration at room temperature

Degradation of particulate matter utilizing non-thermal plasma: Evolution laws of morphological micro-nanostructure and elemental occurrence state

VOCs degradation with non-thermal plasma and Ag-MnOx catalysis

Evolution of particulate matter deposited in the DPF channel during low-temperature regeneration by non-thermal plasma

Fundamentals and Environmental Applications of Non-thermal Plasmas: Multi-pollutants Emission Control from Coal-Fired Flue Gas

Degradation of Nitenpyram Pesticide in Aqueous Solution by Low-Temperature Plasma

Temperature-programmed oxidation of diesel particulate matter in a hybrid catalysis–plasma reactor

Nano-particle Characteristic Emitted from Gasoline Direct Injection Engine Equipped with Non-Thermal Plasma Device

Sustainable Removal of Particulate Matter from Diesel Engine Exhaust at Low Temperature Using a Plasma-Catalytic Method

Nitrogen oxide removal by non-thermal plasma for marine diesel engines

Effect of gas temperature on carbon soot oxidation via non-thermal plasma: two-dimensional numerical study integrating reactive flow and discharge models

Study on the Evolution of Physicochemical Properties of Carbon Black at Different Regeneration Stages of Diesel Particulate Filters Regenerated by Non-Thermal Plasma

A Novel Four-Way Plasma-Catalytic Approach for the after Treatment of Diesel Engine Exhausts

An Analysis of Exhaust Emission of the Internal Combustion Engine Treated by the Non-Thermal Plasma