Abstract:The DPF regeneration is crucial for reducing backpressure, minimizing negative impacts on engine power and fuel economy, but the changes in particulate emission characteristics it brings are worth studying. In this study, the influence of DPFs with different soot loadings on exhaust back pressure and particle emission characteristics, as well as the particle number emission, particle size distribution, and thermal field distribution characteristics during regeneration was investigated based on engine bench test. Results reveal that the exhaust back pressure increases linearly with the engine speed, as well as the soot loading. The increase of DPF soot loading leads to a considerable increase in the reduction efficiency of particle number (PN) and particulate matter emissions, especially for the accumulation mode particles. Moreover, the performance in reducing nucleation mode particles is markedly better than that of accumulation mode ones, and this effect is greatly influenced by the engine operating conditions. At the beginning of DPF regeneration, the PN concentration increases sharply, especially the nucleation mode particles. After regeneration, the PN emissions decrease by two orders of magnitude. During regeneration, the particle size distribution exhibits a unimodal distribution, with the peak value increasing considerably and shifting toward smaller particle sizes. After regeneration, the particle size of the PN peak value slightly decreases and markedly shifts toward larger sizes, the accumulation mode particle concentration increases by 7.2 times, and the nucleation mode particle concentration increases by 2.6 times. Before the DPF regeneration, the axial temperature gradually decreases along the direction of the airflow, and the radial temperature gradually decreases from the center to the edge. During regeneration, the highest temperature occurs in the center of the DPF cross-section, whereas the temperature peak at the outlet interface occurs at the middle position of the DPF. The findings of this paper can provide scientific references to formulation and optimization of DPF regeneration strategies.

Effect of Temperature-controlled conditions on the decomposition of particulate matter deposited in the diesel particulate filter channel by treatment with Non-thermal plasma

Evolution of particulate matter deposited in the DPF channel during low-temperature regeneration by non-thermal plasma

Effect of non-thermal plasma injection flow rate on diesel particulate filter regeneration at room temperature

Effect of Reaction Temperature on the Degradation and Oxidation Behavior of Particulate Matter by Nonthermal Plasma

Non-thermal lasma assisted incineration of particulate matter

Study on the Evolution of Physicochemical Properties of Carbon Black at Different Regeneration Stages of Diesel Particulate Filters Regenerated by Non-Thermal Plasma

The effect of nonthermal plasma on the oxidation and removal of particulate matter under different diesel engine loads

Experimental Study on the Temperature Characteristics of a Diesel Particulate Filter During a Drop to Idle Active Regeneration Process

Degradation of particulate matter utilizing non-thermal plasma: Evolution laws of morphological micro-nanostructure and elemental occurrence state

Effect of nonthermal plasma with different ozone concentrations on the oxidation and removal of different components in particulate matter

Influence of the Engine Drop-to-idle Process on Regeneration Temperature, Filtration and Morphology Characteristics of Diesel Particulate Filters

An investigation of the treatment of particulate matter from gasoline engine exhaust using non-thermal plasma

Experimental Study of Non-Thermal Plasma on Simulated Diesel Emissions

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution

Investigations on the Temperature Distribution of the Diesel Particulate Filter in the Thermal Regeneration Process and Its Field Synergy Analysis

Study on Characteristics and Control Strategy of Diesel Particulate Filters Based on Engine Bench

Pyrological characteristics of burner-type diesel particulate filter for regeneration

Effect of ash on temperature and particulate emission characteristics of diesel particulate filter during active regeneration

Temperature-programmed oxidation of diesel particulate matter in a hybrid catalysis–plasma reactor

Changes of Diesel Particle Diameter and Surface Area Distributions by Non-Thermal Plasma.

Diesel Exhaust Treatment by a Combination of Non‐thermal Plasma with Nano‐CeO2 Supported on the Wood Fiber Filter