Abstract:The DPF regeneration is crucial for reducing backpressure, minimizing negative impacts on engine power and fuel economy, but the changes in particulate emission characteristics it brings are worth studying. In this study, the influence of DPFs with different soot loadings on exhaust back pressure and particle emission characteristics, as well as the particle number emission, particle size distribution, and thermal field distribution characteristics during regeneration was investigated based on engine bench test. Results reveal that the exhaust back pressure increases linearly with the engine speed, as well as the soot loading. The increase of DPF soot loading leads to a considerable increase in the reduction efficiency of particle number (PN) and particulate matter emissions, especially for the accumulation mode particles. Moreover, the performance in reducing nucleation mode particles is markedly better than that of accumulation mode ones, and this effect is greatly influenced by the engine operating conditions. At the beginning of DPF regeneration, the PN concentration increases sharply, especially the nucleation mode particles. After regeneration, the PN emissions decrease by two orders of magnitude. During regeneration, the particle size distribution exhibits a unimodal distribution, with the peak value increasing considerably and shifting toward smaller particle sizes. After regeneration, the particle size of the PN peak value slightly decreases and markedly shifts toward larger sizes, the accumulation mode particle concentration increases by 7.2 times, and the nucleation mode particle concentration increases by 2.6 times. Before the DPF regeneration, the axial temperature gradually decreases along the direction of the airflow, and the radial temperature gradually decreases from the center to the edge. During regeneration, the highest temperature occurs in the center of the DPF cross-section, whereas the temperature peak at the outlet interface occurs at the middle position of the DPF. The findings of this paper can provide scientific references to formulation and optimization of DPF regeneration strategies.

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines.

An experimental investigation of particulate emission characteristics of catalytic diesel particulate filters during passive regeneration

Study of Soot Dynamic Behavior and Catalytic Regeneration in Diesel Particulate Filters

Low temperature, medium temperature and high temperature performance of the continuous regenerative diesel particulate filter assisted by electric regeneration

Methodology of diesel particulate filter testing on test bed for non-road engine application

Research on the filtration and regeneration of fuel borne catalyst diesel particulate filter of diesel engine

Analysis of Temperature and Pressure Characteristics in Catalyzed Diesel Particulate Filter Operation for Heavy-Duty Diesel Engine

Study of the Particulate Purification Efficiency of Diesel Oxidation Catalyst and Catalyzed Diesel Particulate Filter

Modeling of Soot Fragmentation That Proceeds in a Catalyzed Diesel Particulate Filter of a Diesel Engine

Multi-objective Optimization of Composite Regeneration Performance of a CeO2-based Catalyzed Diesel Particulate Filter

An Experimental Study about the Characteristics of Reciprocating Flow Regeneration of Diesel Particulate Filter with Diesel Vapor Injection

Impacts of Continuously Regenerating Trap and Particle Oxidation Catalyst on the NO2 and Particulate Matter Emissions Emitted from Diesel Engine.

Experimental Study on a Diesel Particulate Filter with Reciprocating Flow.

A Research on the Filtration and Regeneration of Fuel Borne Catalyst Diesel Particulate Filter of Diesel Engine

Filtration Efficiency and Regeneration Behavior in a Catalytic Diesel Particulate Filter with the Use of Diesel/Polyoxymethylene Dimethyl Ether Mixture

Study on Characteristics and Control Strategy of Diesel Particulate Filters Based on Engine Bench

Influence of the Engine Drop-to-idle Process on Regeneration Temperature, Filtration and Morphology Characteristics of Diesel Particulate Filters

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution

Numerical simulation study on soot continuous regeneration combustion model of diesel particulate filter under exhaust gas heavy load

Numerical study on the regeneration characteristics of catalytic diesel particulate filter based on real driving emissions in plateau environment

Experimental Investigation on the DPF High-Temperature Filtration Performance under Different Particle Loadings and Particle Deposition Distributions