Abstract:The DPF regeneration is crucial for reducing backpressure, minimizing negative impacts on engine power and fuel economy, but the changes in particulate emission characteristics it brings are worth studying. In this study, the influence of DPFs with different soot loadings on exhaust back pressure and particle emission characteristics, as well as the particle number emission, particle size distribution, and thermal field distribution characteristics during regeneration was investigated based on engine bench test. Results reveal that the exhaust back pressure increases linearly with the engine speed, as well as the soot loading. The increase of DPF soot loading leads to a considerable increase in the reduction efficiency of particle number (PN) and particulate matter emissions, especially for the accumulation mode particles. Moreover, the performance in reducing nucleation mode particles is markedly better than that of accumulation mode ones, and this effect is greatly influenced by the engine operating conditions. At the beginning of DPF regeneration, the PN concentration increases sharply, especially the nucleation mode particles. After regeneration, the PN emissions decrease by two orders of magnitude. During regeneration, the particle size distribution exhibits a unimodal distribution, with the peak value increasing considerably and shifting toward smaller particle sizes. After regeneration, the particle size of the PN peak value slightly decreases and markedly shifts toward larger sizes, the accumulation mode particle concentration increases by 7.2 times, and the nucleation mode particle concentration increases by 2.6 times. Before the DPF regeneration, the axial temperature gradually decreases along the direction of the airflow, and the radial temperature gradually decreases from the center to the edge. During regeneration, the highest temperature occurs in the center of the DPF cross-section, whereas the temperature peak at the outlet interface occurs at the middle position of the DPF. The findings of this paper can provide scientific references to formulation and optimization of DPF regeneration strategies.

Study on Burner Type Diesel Particulate Filter System Using Compressed Air from Turbocharger

An Assessment of the Application of Catalyst Preheating Prior to Engine Cold Start to Improve the Filtration Performance of CDPF on Particulate Emissions

A Study on the Compound Regeneration Control Strategy for DPF Using Burner and DOC

Study on Characteristics and Control Strategy of Diesel Particulate Filters Based on Engine Bench

Design and Experimental Study on an Equipment for Heating Exhaust from Turbocharged Diesel Engine

Methodology of diesel particulate filter testing on test bed for non-road engine application

Full course evolution characteristics of DPF active regeneration under different inlet HC concentrations

Diesel particulate filter regeneration mechanism of modern automobile engines and methods of reducing PM emissions: a review

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution

Effect of regeneration method and ash deposition on diesel particulate filter performance: a review

Effect of ash on temperature and particulate emission characteristics of diesel particulate filter during active regeneration

Numerical Simulation of Diesel Particulate Filter Regeneration Considering Ash Deposit

Review of the State-of-the-art of Exhaust Particulate Filter Technology in Internal Combustion Engines

An experimental investigation of particulate emission characteristics of catalytic diesel particulate filters during passive regeneration

Experimental and Simulation Study on Diesel Spray Oxidation During Active Regeneration of DPF

Simulation of Hydrocarbon Injection used for Catalyzed Diesel Particulate Filter during Active Regeneration Process

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines.

Comparison of the Use of Real Diesel Soot and Soot Surrogate in the Performance Analysis of Diesel Particulate Filters

A review of regeneration mechanism and methods for reducing soot emissions from diesel particulate filter in diesel engine

A Method of Improving of Capture Efficiency of Radial Diesel Particulate Filter

Temperature characteristics of silicon carbide particulate filter during drop-to-idle regeneration applied to a diesel vehicle