Abstract:Purpose: To evaluate long-term survival rates and radiographic stability of sinus floor elevations carried out using a two-layer grafting technique. Materials and methods: Records were analyzed for patients treated with sinus floor elevations using a modified technique. Phycogenic hydroxyapatite (Algipore, Dentsply Sirona Implants) and autogenous bone particles harvested from intraoral sites were grafted in two distinct layers after elevation of the sinus mucosae. In this approach, the basal part of the sinus floor is grafted with autogenous bone, while the cranial part is grafted with the phycogenic hydroxyapatite. In some cases, implants were placed simultaneously, such that the entire surface of each implant was covered by autogenous bone particles. A titanium membrane was used to close the sinus window, and the implants were loaded 3 months later. In two-stage approaches, the implants were inserted 3 to 4 months after the grafting and loaded after 3 additional months. Panoramic radiographs were taken after the grafting procedure, after implant insertion, after the prosthetic restoration, and then annually for 10 years. These radiographs were used to measure the height between the implant shoulders and the top of the graft. Results: Of the 214 sinus floor elevations performed on 129 patients using the bilayering technique, 198 procedures in 118 patients were included in the study (136 one-stage and 62 two-stage). Membrane perforations during surgery occurred in 17.9% of the procedures and were sutured and sealed with fibrin glue. A total of 487 implants were placed in the grafted areas. No severe postoperative complications occurred, but three implants were lost throughout the 10-year follow-up period. A small decrease of vertical height was observed between the grafting surgery and the stage-two surgery (mean: 1.8 mm). After that, no bone height was lost over the 10 years. Conclusion: The layer grafting technique in combination with sinus floor elevation resulted in radiographically stable vertical bone height for 10 years. This technique enabled early placement and loading of implants in the grafted areas. The survival rate obtained with this procedure is similar to that expected for implants placed in nongrafted areas.

Double layer graft technique for horizontal alveolar ridge augmentation with staged implant placement: radiographic histological and implant stability analysis–a case report

Radiographic Evaluation of the Tenting Screw Technique in Horizontal Alveolar Bone Augmentation: A Retrospective Study

Bilamina Cortical Tenting Grafting Technique for Three-Dimensional Reconstruction of Severely Atrophic Alveolar Ridges in Anterior Maxillae: A 6-Year Prospective Study.

Guided Bone Regeneration for Horizontal Maxillary Alveolar Ridge Augmentation Using Patient-Specific Solid Titanium Barriers: A Case Series

Histological Evaluation of Alveolar Ridge Preservation Using Different Bone Grafts: Clinical Study Analysis Part II

Alveolar ridge augmentation using autogenous bone graft and platelet-rich fibrin to facilitate implant placement

Lateral Alveolar Ridge Augmentation with Autogenous Tooth Roots and Staged Implant Placement—5-Year Follow-Up Case Series

Technical Considerations and Case Series Reports

Alveolar Ridge Preservation Using a Collagenated Xenograft: A Randomized Clinical Trial

Horizontal Alveolar Ridge Splitting and Expansion

Stability of Grafted Implant Placement Sites After Sinus Floor Elevation Using a Layering Technique: 10-Year Clinical and Radiographic Results

Staged horizontal bone augmentation for dental implants in aesthetic zones: A prospective randomized controlled clinical trial comparing a half-columnar bone block harvested from the ramus versus a rectangular bone block from the symphysis.

EVALUATION OF ONE-STAGE INVERTED U-SHAPED RIDGE SPLITTING AND CONCURRENT IMPLANT PLACEMENT IN ANTERIOR MAXILLARY UNDERCUT DEFECT(A CLINICAL TRIAL)

Surgical management of deficient alveolar ridges by means of guided bone regeneration in oral implantology

[Clinical Effects of Ridge Augmentation with the Half-Columnar Shaped Mandibular Bone Block for the Placement of Dental Implants].

Modified 3-Dimensional Alveolar Ridge Augmentation in the Anterior Maxilla: A Prospective Clinical Feasibility Study

Versatility of Vertical Distraction Osteogenesis and Sticky Bone in Three-Dimensional Augmentation for Atrophic Alveolar Ridge

Evaluation of the Effectiveness of Bone Grafting in Alveolar Ridge Augmentation Using the Two-Stage Splitting Technique

Horizontal ridge augmentation in the maxillary aesthetic region using the autogenous circular cortical‐lamina anchoring technique: A case series study

Horizontal Alveolar Bone Augmentation using Guided Bone Regeneration Following Alveolar Bone Decortication or Demineralization (Clinical and Histological study)

Comparative analysis of two biomaterials mixed with autogenous bone graft for vertical ridge augmentation: A histomorphometric study in humans