Versatility of Vertical Distraction Osteogenesis and Sticky Bone in Three-Dimensional Augmentation for Atrophic Alveolar Ridge

Abdelaziz Abdullah,Hossam Eldin Ali,Amany El-Sayed
DOI: https://doi.org/10.21608/aadj.2022.212224
2022-01-01
Abstract:Aim. This prospective study was designed to evaluate three-dimensional(3-D) alveolar ridge augmentation through two stages surgical approach, using verticalalveolar distraction osteogenesis (VADO) followed by onlay sticky bone covered bycollagen membrane, for augmentation of the atrophic alveolar ridge to facilitate implantinstallation. Subjects and Methods: Ten patients with atrophic alveolar ridge weretreated by VADO. After bone consolidation the distractors were removed, implantswere inserted, sticky bone graft was packed at buccal aspect, and covered by guidedtissue regeneration (GTR) membrane. The implants were loaded after three monthsof its placement. Clinical evaluation was done to assess wound healing and implantstability. Also, the following parameters were evaluated on orthopantomographyand cone–beam computed tomography; relapse in the distracted bone, crestal boneloss around the implant and bone density around the implant. All data was statisticalanalysed. Results: Mean vertical bone gain was 6.5 mm (range 5-8 mm), and the meanwidth gain was 4 mm ( range 3-5mm). There was 100% survival rate of all implants.There was significant decrease in the mean bone height throughout all periods. Also,significant improvement in bone density around the implant was reported along followup periods. Conclusion: VADO followed by onlay sticky bone graft with GTR can besuccessfully performed to gain proper 3-D measurements of alveolar ridge that areessential for ideal implant installation in severe atrophic mandibular alveolar ridge.
What problem does this paper attempt to address?