Abstract:In this study, low energy ball milling and spark plasma sintering techniques prepared the in-situ synthesized Ti 5 Si 3 reinforced Ti-6Al-4V (TC4) matrix composites and then rolled them at high temperatures. In the composites with high Si content, the Ti 5 Si 3 particles distributed at the interface of α-phase and β-phase agglomerated and then formed a quasi-continuous network structure, which will deteriorate the plasticity of the composites. After hot rolling, the grains of the composite were significantly refined, and more Ti 5 Si 3 particles were precipitated. With the increase in Si content, the tensile strength of sintered composites increased slightly, but the elongation decreased greatly. After hot rolling, the tensile strength of the composite increased significantly with an increment of 359.4 MPa, among which the composite with 0.6 wt% Si achieved a synchronous increase in strength and plasticity. The strengthening mechanism of sintered composites included dislocation strengthening, solution strengthening, and grain refinement, among which dislocation strengthening and grain refinement were the main strengthening mechanisms. The strengthening mechanism of rolled composites was mainly the dislocation strengthening caused by rolling, the grain refinement, and the mismatch of thermal expansion coefficient.

EFFECTS OF HOT-ROLLING PROCESSES ON THE FRACTURE BEHAVIORS AND MECHANICAL PROPERTIES OF 2009Al/SiCp METAL MATRIX COMPOSITES

Effect of Hot Rolling on Microstructures and Mechanical Properties of SiCp/A356 Aluminum Matrix Composites

Effect of hot rolling on microstructures and mechanical properties of SiC p /A356 aluminum matrix composites

Effects of Hot Rolling on Microstructure and Properties of a 20 Vol.% SiC P /al Composite

Numerical simulation of continuous hot rolling process for ultra-thick SiCp/2009Al composites plate

Effect of Rolling Parameters on Microstructure, Texture, and Mechanical Properties of Al/Mg/Al Laminated Composites

Investigation on Various Ceramic Nanoparticles Reinforced Aluminum Matrix Composites Via Accumulative Roll Bonding and Cryorolling

Effects of Hot Rolling, Intermediate Annealing and Cold Rolling on Microstructure, Texture and Mechanical Properties of an Al-Mg-Si-Cu Alloy

Microstructure and mechanical properties of in-situ Ti 5 Si 3 /TC4 composites via spark plasma sintering and hot rolling

Evolution of Microstructure, Texture and Mechanical Properties of SiC/AZ31 Nanocomposite During Hot Rolling Process

Effects of Hot Rolling on Microstructure, Macrotexture and Mechanical Properties of Pre-Extruded Az31/Sic Nanocomposite Sheets

Microstructure, Mechanical and Thermal Properties of Al/Cu/SiC Laminated Composites, Fabricated by the ARB and CARB Processes

Microstructures and Properties of Al 27 % Si Composites : in Fl Uence of Rolling and Annealing

Effects of Direct Rolling Deformation on the Microstructure and Tensile Properties of the 2.5 Vol% (tibw+ticp)/ti Composites

Microstructure and mechanical properties of SiCp/AZ91 composites processed by a combined processing method of equal channel angular pressing and rolling

Microstructure and Mechanical Properties of In-Situ Ti5Si3/TC4 Composites Via Spark Plasma Sintering and Hot Rolling

Mechanical Properties and Tensile Fracture Mechanism Investigation of Al/Cu/Ti/Cu/Al Laminated Composites Fabricated by Rolling

Microstructural homogeneity, mechanical properties, and wear behavior of in situ Mg2Si particles reinforced Al–matrix composites fabricated by hot rolling

Microstructural Modification and Strength Enhancement by SiC Nanoparticles in AZ31 Magnesium Alloy During Hot Rolling

Formation and effect of intermetallic compounds in the interface of copper/aluminum composites under rolling conditions

Effect of cold-rolling on tensile strength of SiCw/Al composite