Abstract:In this paper, a three-phase, two stage, bidirectional off board plug-in Electric Vehicle (PEV) charger controller has been designed and implemented in real time. The proposed PEV charger is able to work in all four quadrants in active-reactivepower plane. Generally, power electronics converters are controlled by PI regulators in d-q reference frame, where the signals to be regulated are inherently DC in nature. These controllers are implemented in two loops i.e., Slow (outer) control loop and fast (inner) control loop. Setting the gains of outer loops are little bit easier in comparison to fast acting inner loops besides the involvement of decoupling terms to have independent operation of active and reactive current components. Therefore, a repetitive controller (RC) is designed to regulate the inner sinusoidal reference current having both active-reactive components as per the control requirement without involving any decoupling terms. The RC is well known for their ability to track periodic signal and inherently based on internal model control theory. However, the major problem with RC is its sensitivity due to which it provides high gains at all frequencies levels. Therefore, in proposed controller the sensitivity of RC is modified by squaring it. This results the deep notches at higher frequency levels This approach is found to be very much suitable for the compensation of reactive power and load current harmonics. This also helps to exclude unwanted frequencies which results reduction in THD level. Therefore, the main contribution of this paper is adapting such robust EV charger controller for harmonic compensation. Moreover, from the implementation, it is found that the conventional RC is capable to compensate load current harmonic to some extent but it takes around 140 μs computational time. However, the proposed RC takes around 100 μs computational time, this results the grid current purely sinusoidal. The MATLAB/Simulink environment has been used to simulate proposed PEV charger controller, further it has been verified on scaled down experimental prototype.

Design of Current Controller for Two Quadrant DC Motor Drive by Using Model Order Reduction Technique

A novel harmonic elimination approach in three-phase multi-motor drives

Accurate Two-Degree-of-freedom Discrete-Time Current Controller Design for PMSM Using Complex Vectors

Design and Implementation of Closed-Loop Controller with Current Sensors for Brushless DC Motor Drives

Independent Current Control of Dual Parallel SRM Drive Using a Public Current Sensor

A New Phase Current Reconstruction Scheme For Four-Phase Srm Drives Using Improved Converter Topology Without Voltage Penalty

Open-Loop Validation of a decoupled model of an Induction Motor Supplied by a PWM Inverter

A Combined Finite Element-Domain Elimination Method for Minimizing Torque Ripples in Inverter-Fed AC Motor Drive Systems

Improved Model Predictive Current Control for PMSM Drives Based on Dynamic Reference Current

Analysis for Drive Circuit and Improved Current Controller for Proportional Amplifier

Optimum Design of Switched Reluctance Motor Based on Direct Instantaneous Torque Control

Design of speed regulation system of reversible DC motor

Order Reduction of Linear Dynamic Systems by Improved Routh Approximation Method

Design and Development of Cascaded Current Control in DC Motor Variable Speed Drive using dSPACE

Design of high-speed four-phase SRM motor and its overload control using fractional-order controller

High-Performance Current Control for Switched Reluctance Motors Based on On-Line Estimated Parameters

Application of quadratic linearization state feedback control with hysteresis reference reformer to improve the dynamic response of interior permanent magnet synchronous motors

A Systematic Approach to Digital Control Development for Four-Phase SRM Drive Using Single Current Sensor for Medium Power Applications

Modified repetitive control design for two stage off board Electric Vehicle charger

Close Loop Feedback Direct Current Control in Driving Mode of a Four Quadarnts Drive Direct Current Chopper for Electric Vehicle Traction Controlled Using Fuzzy Logic

Current Harmonics Controller for Reduction of Acoustic Noise, Vibrations and Torque Ripple Caused by Cogging Torque in PM Motors under FOC Operation