Abstract:The effect of annealing temperature (T a = 200, 250, and 300 °C) on the structural properties, ac conductivity, and complex dielectric constants ( and ) of indium-doped tin oxide (ITO) thin films (~ 90 nm thick)/0.5 mm boro-float substrates (BFS) synthesized by radio frequency (RF) sputtering is investigated. The X-ray diffraction (XRD) examination demonstrated that indium was successfully substituted with tin atoms to form ITO films and the crystallite size for the cubic phase, as well as particle size, were impacted by T a . The real part of complex dielectric constants ( ) was significantly reduced for all ITO/BFS from the range of 2.7 × 10 4 –5.1 × 10 4 to 5.3–19 as the frequency ( f ) was increased to 0.25 Hz, while it remained constant for further increases in f . The value of for the as-prepared ITO/BFS was increased as T a increased up to 250 °C, then was decreased at T a =300 °C. A similar finding was detected for the loss factor with no observation of any relaxation peaks. The Q-factor was increased for all ITO/BFS as f increased to 100 Hz and then was reduced with increasing f up to 20 MHz, while steadily increasing with T a . The deduced frequency exponent is greater than 0.5 for the ITO/BFS, indicating their electronic conduction nature. The density of the localized states and hopping frequency of the ITO/BFS were increased by annealing at 200 °C, meanwhile was decreased for T a = 300 °C. The binding energy was decreased from 0.647 eV for the as-prepared ITO/BFS to 0.518 eV by annealing at 200 °C, meanwhile was increased to 0.74 and 0.863 eV for T a equals 250, and 300 °C, respectively. The Cole-Cole plots revealed a single semicircular arc for all films, and their corresponding equivalent circuit was analyzed. The equivalent bulk resistance was gradually decreased by annealing in the range of 200–300 °C, whereas the equivalent capacitance was increased. The resistance of grains and resistance of grain boundaries of the as-prepared ITO/BFS was gradually decreased by increasing T a to 250 °C, while it was increased for T a = 300 °C. These outcomes recommended the RF sputtered ITO/BFS for high-frequency devices, integrated circuits, and supercapacitors.

Diffusion behaviors of Sn dopant in ITO films upon supercritical CO 2 treatment and annealing

Abnormal Behaviors in Electrical Transport Properties of Cobalt-Doped Tin Oxide Thin Films

P-type Tin–indium Oxide Films Prepared by Thermal Oxidation of Metallic InSn Alloy Films

Enhancement in photoelectric properties of ITO films by regulating defects and dopants with supercritical fluid treatment

The key of ITO films with high transparency and conductivity: Grain size and surface chemical composition

Preparation and Electrical Properties of Electrospun Tin-Doped Indium Oxide Nanowires

In Situ Optical Characterizations of the Annealing Effects Upon Sno2: F Films by Spectroscopic Ellipsometry

Air-Annealing Effects on Sio2/Ito Coating

Study of Annealing Effects Upon the Optical and Electrical Properties of SnO2:F/SiCxOy Low Emissivity Coatings by Spectroscopic Ellipsometry

Combined effects of substrate temperature and post annealing temperature on structural, optical and electrical properties of Sb-doped SnO 2 films

Annealing effects of In2O3 thin films on electrical properties and application in thin film transistors

Studies on the Structural and Electrical Properties of F-Doped Sno2 Film Prepared by Apcvd

Correlation between microstructure and electrical, optical properties of thermal annealed ITO thin films

Effect of annealing temperature on the structure and dielectric characterization of ITO thin films on a boro-float substrate prepared by radio frequency sputtering

Synchrotron Radiation Photoelectron study of ITO surface

X-Ray Photoelectron Spectroscopy Studies Of Indium-Tin-Oxide Treated Via Oxygen Plasma Immersion Ion Implantation

Effect of Nitrogen Doping Temperature on the Resistance Stability of ITO Thin Films

Effects of annealing temperature on properties of InSnZnO thin film transistors prepared by Co-sputtering.

Effects of the Variations of Oxide Structure on the Electrical and Optical Properties of ITO Films

Plasma-enhanced atomic layer deposition of Sn-doped indium oxide semiconductor nano-films for thin-film transistors

Electronic conduction properties of indium tin oxide: single-particle and many-body transport