Abstract:Porous MgO based ceramics have been widely used in some key industries due to their excellent performance. To investigate the feasibility of preparing porous magnesia ceramics using magnesite tailings as a magnesium source. Porous MgO based ceramics were prepared using magnesite tailings, fused magnesia as main raw materials and soluble starch as pore-forming agent. The starting materials were mixed in different ratios and sintered at 1500 °C for 2 h to obtain good mechanical and thermophysical properties. The Mg 2 SiO 4 plays a fixing role, inhibiting the growth of MgO grains and further promoting the discharge of pores. This fixation can prevent the linear expansion of cracks, thus increasing the fracture surface energy of the specimen. In addition, the scattering effect of pores on gas molecules decreases as the magnesite tailings content increase, so that the thermal conductivity increases. The results showed that when the mass ratio of magnesite tailings to fused magnesia was increased from 1:1 to 1:0 with 4 wt% soluble starch as the pore-forming agent, the apparent porosity decreased from 35.59% to 11.8%; the bulk density increased from 2.37 to 2.82 g∙cm −3 ; the linear shrinkage ratio increased from 9.28 to 24.23%; the cold compressive strength increased from 47.75 to 226.52 MPa; the residual strength retention rate after one thermal shock cycles at 1100 °C was between 64.05 and 87.76%; and the thermal conductivity increased from 7.44 to 12.23 W∙m −1 K −1 .

Synthesis of MgO powders by precipitant for transparent ceramics

Fabrication of Y2O3-doped MgO Refractory Raw Materials Based on Magnesium Hydroxide from Salt-Lake Brine

Nanosized MgO Powder Preparation by Homogeneous Precipitation-Post Annealing Method Using Mg(NO3)2·6H2O as Raw Material

Fabrication of MgO-Y2O3 Composite Nanopowders by Combining Hydrothermal and Seeding Methods

MgO nanostructures synthesized by thermal evaporation

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

Preparation of Ccalcining MgO and its precursor

Preparation of transparent MgAlON ceramics with tunable compositions

MgO Assisted Densification of Highly Transparent YAG Ceramics and Their Microstructural Evolution

Synthesis of Y2O3 nanopowders and transparent Y2O3 ceramics by carbonate-precipitation process

Influence of CaO on microstructure and properties of MgAl2O4 transparent ceramics

Effect of Al2O3 and TiO2 Addition Amount on Properties of MgO-based Ceramics by Coprecipitation Method

Synthesis of Yttria Nanopowders for Transparent Yttria Ceramics

Effect of CaO additive on the densification of MgO and MgO-YGAG:Ce ceramics

Preparation of Nanometer Magnesia with High Surface Area and Study on the Influencing Factors of the Preparation Process

Optimizing co-precipitated Nd:YAG nanopowders for transparent ceramics

Influence of Gd2O3 on the microstructure and properties of transparent MgAl2O4: Cr3+ ceramic

The effects of solvent and microwave on the preparation of Magnesium Oxide Precursor: The effects of solvent and microwave on the preparation of Magnesium Oxide Precursor

A Novel Spray Co-Precipitation Method to Prepare Nanocrystalline Y2O3 Powders for Transparent Ceramics

Preparation and properties of porous MgO based ceramics from magnesite tailings and fused magnesia

Porous MgO-based ceramics synthesized by the volume expansion effect: Designing and performance