Cooling of suspended nanostructures with tunnel junctions

P.J. Koppinen,I.J. Maasilta

DOI: https://doi.org/10.1088/1742-6596/150/1/012025

2009-01-20

Abstract:We have investigated electronic cooling of suspended nanowires with SINIS tunnel junction coolers. The suspended samples consist of a free standing nanowire suspended by four narrow ($\sim$ 200 nm) bridges. We have compared two different cooler designs for cooling the suspended nanowire. We demonstrate that cooling of the nanowire is possible with a proper SINIS cooler design.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: how to effectively cool suspended nanostructures (such as nanowires) at extremely low temperatures, especially cooling their electron and phonon modes. Specifically, the author studied the possibility of electron cooling of suspended nanowires using SINIS tunnel - junction coolers and explored the influence of different cooler designs on the cooling effect.

### Background and Challenges

1. **Challenges at Ultra - Low Temperatures**:
- Reaching ultra - low temperatures (such as sub - Kelvin temperatures) is a great challenge and usually requires complex refrigeration techniques, such as dilution refrigeration or adiabatic demagnetization.
- In nano - scale samples, a tiny external heat load (about pW level) may significantly heat the sample because the heat dissipation mechanism in nanostructures is very weak.

2. **Requirement for Local Cooling**:
- Traditional NIS coolers are mainly used to cool small metal islands on the substrate, mainly cooling the electron gas rather than the substrate itself.
- Many applications (such as cryogenic detectors and mechanical resonators) require simultaneous cooling of electron and phonon modes, which has been achieved in thin - film structures through large - area NIS junctions, but has not been reported in suspended nanowires yet.

### Research Objectives

- **Explore the Cooling of Suspended Nanowires**: Study whether the electron and phonon modes of suspended nanowires can be cooled through appropriate SINIS cooler designs.
- **Compare Different Cooler Designs**: Compare two different cooler designs and evaluate their influence on the cooling effect of suspended nanowires.

### Main Findings

- **Cooling Effect Depends on Cooler Position**:
- When the cooler is located at the free end of the support bridge, the cooling effect is not obvious because the recombined phonons are difficult to escape effectively, resulting in being re - absorbed by the normal metal.
- When the cooler is located on the substrate, the cooling effect is significant, and the temperature can be reduced from 200 mK to 110 mK because the recombined phonons can directly escape into the three - dimensional substrate and will not be re - absorbed.

### Conclusions

- Using an appropriate SINIS cooler design can effectively cool the electrons of suspended nanowires below the ambient temperature.
- The influence of the narrow structure of the support bridge on phonon transmission is the key factor leading to different cooling effects.
- This research result provides the possibility for cooling nano - mechanical resonators to their ground state in the future and lays the foundation for further optimizing the cooling efficiency.

Through this research, the author has demonstrated the potential for achieving efficient local cooling at the nano - scale, opening up new avenues for future low - temperature applications.