Abstract:Modern aviation components have higher requirements for high temperature resistance, high strength and lightweight materials, and ceramic matrix composites have superior overall performance. However, its high brittleness and anisotropy lead to a challenge for manufacturing. In order to understand the formation conditions and the evolution of surface microstructures of the Cf/SiC microgrooves processed by ultrafast laser comprehensively, we designed a single-factor experiment and performed sensitivity analysis. The experiment results showed that the pulse energy had great effects on the depth of the microgroove, and the intense ablation caused more active oxidation of SiC to occur, generating more SiO(g). However, too much pulse energy may cause the material removal mechanism to be more due to the photothermal effect rather than the plasma effect. Low repetition frequency caused a large number of laminated connections in the microgroove and the oxide gradually changed from lumpy to flocculent as the repetition frequency increased. The more scanning times, the more ablation products sputtered onto the sample surface, including unablated carbon fibers. Shallow depth and ablation residues remained in the microgroove occurred under few scanning times. Although too fast scanning speed leaded to a rapid decrease in the microgroove depth, too slow scanning speed also generated more unablated carbon fibers sputtering out of the microgrooves. The microgroove depth had the highest sensitivity to the repetition frequency, followed by the pulse energy and scanning speed. The pulse energy and scanning speed had a greater effect on the oxide layer height, the repetition frequency affected the oxide layer width, and the scanning speed affected the microgroove width significantly. According to the processing requirements and the hot spot map, the processing parameters that can be adjusted effectively will be able to be obtained.

Research on hole depth in femtosecond laser deep micropore processing technology based on filament effect

Research on Microhole Processing Technology Based on the Femtosecond-Laser Spiral Trepanning Method

Effect of machining parameter on femtosecond laser drilling processing on SiC/SiC composites

Experimental Investigation of Water Jet-Guided Laser Micro-Hole Drilling of Cf/SiC Composites

Experimental Research on CO_2 Laser Direct-writing Machining PMMA Microchannel

Microstructure evolution and ablation mechanism of SiCf/SiC ceramic matrix composite microgrooves processed by pico-second laser

A study of laser machining combined with dynamic chemical etching in micro‐hole drilling of 2.5D SiCf/SiC composites

Femtosecond laser drilling of SiC/SiC composites in longitudinal magnetic field and semi-water immersion assistance

Surface microstructure evolution of Cf/SiC ceramic matrix composite microgrooves processed by ultrafast laser

Percussion Drilling of Deep Holes Using Picosecond Ultrashort Pulse Laser in Ni-Based Superalloy Coated with Ceramic Thermal Barrier Coatings

Mass Fabrication of Microholes in Aviation Kerosene Filters Using the Back-water-assisted Picosecond Laser Drilling Technique

Process in laser drilling of deep microholes without taper on metal materials

Investigation of Heat Accumulation in Femtosecond Laser Drilling of Carbon Fiber-Reinforced Polymer

Femtosecond laser filament ablated grooves of SiC ceramic matrix composite and its grooving monitoring by plasma fluorescence

Hole taper control in femtosecond pulsed laser drilling of silicon carbide ceramic

Processing parameter effect, formation mechanism and inhibition method of micro-hole exit defects in rotary ultrasonic pecking drilling of SiC f /SiC composites

Fabrication of millimeter-scale deep microchannels in fused silica by femtosecond laser filamentation effect

Laser drilling in silicon carbide and silicon carbide matrix composites

Experimental Investigation on the Spiral Trepanning of K24 Superalloy with Femtosecond Laser

Water jet guided laser grooving of SiC f /SiC ceramic matrix composites

Femtosecond Laser Drilling of Cylindrical Holes for Carbon Fiber-Reinforced Polymer (CFRP) Composites