Abstract:To investigate the dynamic mechanical behavior and energy dissipation characteristics of low-temperature rock samples under cyclic impact loading, a temperature-controlled impact system that combines Hopkins bars with a low-temperature compensation device was used. Five temperature gradients were confirmed via a trial impact test, and impact tests were conducted under two kinds of impact air pressures. The macroscopic damage characteristics of rock samples under cyclic impact at different temperatures, dynamic stress-strain curves, changes in peak stress and strain, energy dissipation, and cumulative damage at different temperatures, and the macroscopic and microscopic structural characteristics of low-temperature rock samples after cyclic impact were analyzed in combination with damage. The findings indicated that low-temperature saturated granite primarily experienced tensile damage under cyclic impact loading, with the required number of impacts increasing with decreasing temperature, and rock samples exhibited freeze-induced brittleness and significantly increased fragmentation. The dynamic stress-strain curve generally exhibited rebound characteristics in the post-peak stage. With an increasing number of cycles, an overall decrease in peak stress was observed, whereas the peak strain and cumulative specific dissipated energy exhibited opposite trends. This trend was more pronounced at lower temperatures, with a significant increase in peak strain and specific energy amplitude. In addition, the cumulative damage factor of the rock samples increased at lower temperatures, consistent with macroscopic damage characteristics, and exhibited a negative correlation with peak stress. The degree of crack extension in the macroscopic samples corresponded with the observed fracture changes. Microanalysis (SEM) indicated that decreasing temperature resulted in freeze brittleness of the fracture surfaces, characterized by reduced flatness and an expansion of brittle cracks across the damage surface. The slip separation phenomenon became increasingly pronounced, and these observations were positively correlated with the cumulative damage value.

Dynamic compression behaviors of heat-treated granite under combined dynamic and static load

Uniaxial Compressive Behavior of Granite at High Strain Rates

Investigations of the Progressive Damage and Failure Behaviors of Thermally Treated Granite Under the Coupling Action of Biaxial Stress Constraint and High Strain Rate

Experiment and numerical simulation study of dynamic mechanical behavior of granite specimen after high temperature treatment

Dynamic response and fracture characteristics of thermally-treated granite under dynamic loading

Tensile Microcracking Behavior of Granites after High Temperature Treatment by Considering the Effect of Grain Size and Mineralogical Composition

Fractal Characteristics and Energy Dissipation of Granite After High-Temperature Treatment Based on SHPB Experiment

Experiment Study on Shear Behavior and Properties of Granite Fractures under Real-time High-temperature Conditions

Effect of Cyclic Impact on the Dynamic Behavior of Thermally Shocked Granite

Study on the Evolution of Physical Parameters and Dynamic Compression Mechanical Properties of Granite after Different Heating and Cooling Cycles

Experimental study of the influence of temperature and cooling method on dynamic mechanical properties and damage of granite

Dynamic mechanical behavior and energy dissipation characteristics of low-temperature saturated granite under cyclic impact loading

Impacts of different cooling methods on the dynamic tensile properties of thermal-treated granite

Experimental investigation on damage characteristics and fracture behaviors of granite after high temperature exposure under different strain rates

Comparative Study on Mechanical Properties and Crashing Characteristics of Granite After Real-Time High-Temperature and Natural-Cooling

Mechanical test of granite with multiple water–thermal cycles

Mechanical Behaviors of Granite After Thermal Treatment Under Loading and Unloading Conditions

Experimental investigation on the mechanical properties of thermally damaged granite specimens containing pre‐existing holes

Mechanical properties of granite at high temperature subjected to true triaxial compression

Laboratory Investigation on Physical and Mechanical Behaviors of Granite after Heating and Different Cooling Rates

Mechanical and damage evolution characteristics of granite after heating-cooling cycles