Study on the effect of TiC/B on the performance of laser cladding in-situ fabricating wear-resistant self-lubricating coatings

Feng-Hua Liu,Feng-Qin Ji,Ming Pang

DOI: https://doi.org/10.1016/j.mtcomm.2024.110675

IF: 3.8

2024-10-18

Materials Today Communications

Abstract:To improve the wear resistance of IN718, coatings containing the self-lubricating phase h-BN were prepared and the coating properties were analyzed in relation to the variation of laser power. The results show the TiC added to the cladding powder partially decomposes and in-situ fabricates new reinforcing phases TiN, B 4 C, etc. The lubricating phase h-BN was in-situ fabricated by adding B into the powder. As the laser power increased from 1.6 kW to 2 kW and 2.5 kW, eutectic microstructures of high melting point reinforcing and lubricating phases were observed. Due to the decomposition of TiC and in-situ fabricated of TiC 2 , TiN and B 4 C concentrations changing with the laser power, the surface hardness of the coatings prepared at 2.5 kW was the highest at 391.03HV 0.5 . Which is 1.096 and 1.108 times of 1.6 kW and 2 kW. At room temperature, the coating fabricated by 2 kW has the highest average friction coefficient of 0.537. This is because the self-lubricating phase h-BN is a high-temperature lubricating phase and the wear surface has a low oxide content, and is influenced by the hardness of the coating. At 500°C, the coating fabricated with 2.5 kW has the lowest average friction coefficient due to the best synergistic effect of the lubricating and reinforcing phases at 0.376. The 2.5 kW coating has the best wear resistance, with wear rates 0.69 and 0.54 times at room temperature and 0.82 and 0.8 times at 500°C of 1.6 kW and 2 kW. The wear mechanism at room temperature is abrasive wear, and at 500°C is mainly a combination of h-BN and oxide synergistic lubrication.

materials science, multidisciplinary