Abstract:Understanding the initiating and suppression mechanisms of existing defects are the key to optimizing the ultra-precision grinding process of hard and brittle materials. This paper discusses the effects of grinding damage on material removal mechanism from the perspectives of residual scratch depth, scratch morphology and normal scratching force, through conducting the contrast variable-depth nano-scratch experiment on polished and ground monocrystalline silicon and establishing the single grain scratching Smoothed Particle Hydrodynamics (SPH) model. The experimental and simulation results show that radial crack on ground silicon surface is almost invisible due to the existence of grinding marks, which indicates that it is difficult to judge the ductile brittle transition (DBT) point by the traditional method of observing cracks. With the increase of penetration depth, pop-in will occur in the residual scratch depth of polished and ground silicon, indicating that the material removal mode has transformed, which provides an important basis for judging the DBT point. The DBT critical normal scratching force (38.93 mN) and residual scratch depth (−0.14 μm) of ground silicon are much higher than those of polished silicon, implying ground silicon is easier to achieve ductile processing. Meanwhile, when the penetration depth is the same, compared to polished silicon, the normal scratching force of ground silicon is generally larger. Finally, a single grain scratching SPH model of pre-stressed silicon is established. And the simulated phenomenon and conclusions are consistent with the experiment, which proves that the surface compressive stress is an important factor that causes the removal characteristics of ground silicon to be different from polished silicon. This study provides a theoretical basis for understanding the ultra-precision grinding removal mechanism of hard and brittle materials.

Strain rate effect on material deformation and removal behavior during high speed scratching of 4H‐SiC

Molecular dynamics simulation of the material removal in the scratching of 4H-SiC and 6H-SiC substrates

Cutting Speed Dependence of Material Removal Mechanism for Monocrystal Silicon

Polytypic transformation behavior from 4H-SiC to 3C-SiC during high-speed scratching of single crystalline silicon carbide

Molecular Dynamics Simulation of Single-Crystal 4H-SiC Nano Scratching with Different Scratching Directions of the Tool

Atomic Simulations of Deformation Mechanism of 3C-SiC Polishing Process with a Rolling Abrasive

Molecular simulation of ultrasonic assisted diamond grit scratching 4H-SiC single-crystal

On the deformation mechanism of SiC under nano-scratching: An experimental investigation

Anisotropic Deformation of 4H-Sic Wafers: Insights from Nanoindentation Tests

Analysis of the high-efficiency and low-damage abrasive processing mechanism for SiC based on the SPH simulation of single-grain indentation and scratching

Material removal and damage formation mechanisms induced by periodic indentation during ultrasonic vibration-assisted scratching of SiC f /SiC composites

Material deformation and removal mechanism of SiCp/Al composites in ultrasonic vibration assisted scratch test

Investigation of Cutting Force and the Material Removal Mechanism in the Ultrasonic Vibration-Assisted Scratching of 2D-SiCf/SiC Composites

Coupled SPH-FEM modeling of Berkovich indenter scratching of single-crystal silicon

Study on wear of diamond during scratching SiC using molecular dynamics simulations

Experimental Study on Shear Rheological Polishing of Si Surface of 4H-SiC Wafer

Fracture mechanism of ultrasound-assisted scratching 2D-SiCf/SiC composite fibers with different fiber orientations

Effect of grinding damage on cutting force and ductile machining during single grain scratching of monocrystalline silicon

Influence of mechanical properties on material deformation behavior of different ceramics in scratching

Study on morphology reconstruction of SiC ceramics ground by monolayer-patterned grinding wheel considering strain rate effect

Effect of dislocation defects on the nano-scratching process of 4H–SiC