Direct temporal measurement of hot-electron relaxation in a phonon-cooled metal island

D. R. Schmidt,C. S. Yung,A. N. Cleland

DOI: https://doi.org/10.48550/arXiv.cond-mat/0307624

2003-07-25

Abstract:We report temporal measurements of the electronic temperature and the electron-phonon thermal relaxation rate in a micron-scale metal island, with a heat capacity of order 1 fJ/K . We employed a superconductor-insulator-normal metal tunnel junction, embedded in a radio-frequency resonator, as a fast (~ 20 MHz) thermometer. A resistive heater coupled to the island allowed us to drive the electronic temperature well above the phonon temperature. Using this device, we have directly measured the thermal relaxation of the hot electron population, with a measured rate consistent with the theory for dynamic electron-phonon cooling.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to measure the relaxation process of hot electrons in micron - scale metal islands, which specifically includes the following aspects:

1. **Time - domain measurement of electron temperature and electron - phonon thermal relaxation rate**:
The authors used a superconductor - insulator - normal metal (SIN) tunnel junction as a fast (about 20 MHz) thermometer, embedded in a radio - frequency resonator, to measure the electron temperature and electron - phonon thermal relaxation rate in micron - scale metal islands. They increased the electron temperature far above the phonon temperature by means of a resistive heater and directly measured the thermal relaxation of the hot - electron population.

2. **Study of the thermodynamic behavior of small - volume metal systems**:
The paper shows how to detect the electron thermodynamic behavior in very small metal volumes (which may have a heat capacity as low as 10 kB) through this device, which is very important in the field of mesoscopic physics.

3. **Measurement of dynamic electron - phonon cooling**:
The authors carried out the measurement of dynamic electron - phonon cooling by monitoring the time - dependent behavior of the electron temperature at the end of the heating pulse. They found that as the electron temperature approaches the phonon temperature, the relaxation process slows down significantly.

4. **Extraction of heat capacity**:
Through these measurements, the authors were able to directly measure the electron - phonon thermal relaxation and extract the heat capacity of the metal islands from it. This is one of the smallest heat capacities measured so far and provides an important platform for future single - photon and phonon thermometers.

### Formula Explanation

The key formulas involved in the paper are as follows:

- **Power Flow Formula**:
\[
P_{e - p}=\Sigma V\left(T_{e}^{n}-T_{p}^{n}\right)
\]
where \(\Sigma\) is a material - related parameter, \(T_{e}\) and \(T_{p}\) are the electron and phonon temperatures respectively, and \(n = 5\) for spherical Fermi surfaces and Debye phonon gases.

- **Electron Temperature Change Rate**:
\[
\dot{T}_{e}=-\frac{\Sigma}{\gamma}\left(\frac{T_{e}^{n}-T_{p}^{n}}{T_{e}}\right)
\]
where \(\gamma\) is the Sommerfeld constant, which describes the relationship between the electron heat capacity and temperature.

- **Temperature Change Rate at Normalized Temperature**:
\[
\dot{\theta}=-\frac{1}{n\tau_{e - p}(T_{p})}\left(\theta^{n - 1}-\frac{1}{\theta}\right)
\]
where \(\theta=\frac{T_{e}}{T_{p}}\), and \(\tau_{e - p}(T_{p})\) is the electron - phonon relaxation time.

These formulas help the authors understand and explain the phenomena observed in the experiment, thus verifying the theoretical predictions.