Abstract:Accurate measurements of the nanoscale electromechanical coupling in materials, including piezo and ferroelectrics, twisted 2D layers, and biological systems is of both fundamental scientific and applied importance. Piezoresponse Force Microscopy (PFM) is capable of detecting strains in these materials, down to the picometer range. Following the emergence of weaker materials, the smaller signals associated with them have revealed various crosstalk challenges that have limited the accuracy of measurements. Previous work demonstrated that the use of an interferometric displacement sensor (IDS) positioned appropriately above the tip of the cantilever (x/L~1), where x is the spot position and L is the cantilever length, has enabled sensitive and artifact-free electromechanical measurements. A similar approach has been employed in removing unwanted electrostatic and in-plane response contributions for the optical beam deflection (OBD) measurement technique commonly used in most atomic force microscopes. In the present study, extensive automated sub-resonance spot position dependent PFM measurements were conducted on periodically poled lithium niobate (PPLN). In this work, both IDS and OBD responses were measured simultaneously, allowing direct comparisons of the two approaches. The IDS showed a blind spot at x/L~1, as expected. However, for OBD measurements, the blind spot's location exhibited wider variation, ranging from 0.15<x/L<0.61. Furthermore, the magnitudes of the amplitudes measured with IDS and OBD were typically different, sometimes approaching disagreement by a factor of two. These measurements have important implications, not only for the PPLN measured here, but for more complex and unknown samples that have a heterogeneous polarization and electrical characteristic.

Fabry–Perot interferometric calibration of van der Waals material-based nanomechanical resonators

Fabry-Perot Interferometric Calibration of 2D Nanomechanical Plate Resonators

Calibrate the Non-Orthogonal Error of AFM with Two-Dimensional Self-Traceable Grating.

Photothermal Responsivity of van der Waals Material-Based Nanomechanical Resonators

Determination of the effective mass and stiffness of a micro resonator from a single optical characterization

Nanoscale imaging of super-high-frequency microelectromechanical resonators with femtometer sensitivity

Subnanometer Absolute Displacement Measurement Using a Frequency Comb Referenced Dual Resonance Tracking Fabry-Perot Interferometer.

Highly precise nonlinear error calibrating system based on Fabry-Perot interferometer - art. no. 68342X

Femtometer-amplitude imaging of coherent super high frequency vibrations in micromechanical resonators

Accurate Vertical Nanoelectromechanical Measurements

Optoelectrical Nanomechanical Resonators Made from Multilayered Two-Dimensional Materials

Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

Fabry–Perot Interferometer with Picometer Resolution Referenced to an Optical Frequency Comb

Coherent interferometric control of strongly-coupled nano-electromechanical resonators

Enhanced photothermal displacement spectroscopy for thin-film characterization using a Fabry-Perot resonator

Centimeter-scale nanomechanical resonators with low dissipation

Mass sensing for the advanced fabrication of nanomechanical resonators

Dynamic Behavior of Tuning Fork Shear-Force Structures in a SNOM System

Characterization of resonator using confocal laser scanning microscopy and its application in air density sensing

The study on nonlinear error calibrating system based on Fabry-Parot interferometer with an accuracy of nanometer order

Imaging vibrations of locally gated, electromechanical few layer graphene resonators with a moving vacuum enclosure