Abstract:This study deals with the effect of conventional sintering and microwave sintering on the densification kinetics of Titanium Carbide (TiC) in the presence of Ni (1, 1.5, 2 wt%). TiC compacts were obtained after uniaxial pressing of powders synthesised by ball milling of Titanium and Carbon and sintering was done in the presence of Nickel. The samples prepared were subjected to conventional as well as microwave sintering. The XRD and SEM analysis were used for a study of the reaction of Ti and C powders upon addition of Ni, which reduced the sintering temperature to 1200 °C. The densification of TiC powders was due to the Ti-Ni eutectic system, the liquid phase formed at this temperature assisting the sintering process. The SEM images revealed the flake like structure of TiC in which the carbon diffused into Ti upon the addition of Ni, thereby supporting enhanced mass transfer. The XRD pattern showed the presence of Titanium Oxide (TiO2) along with TiC which resulted in non-uniform distribution of hardness. Maximum hardness was achieved in the conventional sintered compacts which gradually increased with increase in Ni addition. The presence of the oxide phase and the formation of micro cracks resulted in non-uniform hardness for microwave sintered compacts. The maximum hardness of conventional sintered compact (375 HLD) was nearly 1.5 times more than the maximum hardness of the microwave sintered compact (250 HLD). The density of the microwave sintered compact was found to be higher by 8% than with the conventionally sintered compact.

Rapid synthesis of nano-TiC particles by microwave heating method

Rapid-Heating-Triggered in Situ Solid-State Transformation of Amorphous TiO2 Nanotubes into Well-Defined Anatase Nanocrystals

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

Investigation of TiC formation during ball-milling of elemental titanium and carbon

Preparation and Sinterability of Submicron Titanium Carbide Powders Synthesized with Phenolic Resin As Carbon Source by Carbothermal Reduction

In-situ Synthesis of Nanocrystalline TiC Powders, Nanorods, and Nanosheets in Molten Salt by Disproportionation Reaction of Ti(II) Species

Rapid one-step scalable microwave synthesis of Ti 3 C 2 T x MXene

Mechanosynthesis Mechanism of Tic Powders

Direct Synthesis of Controllable Microstructures of Thermally Stable and Ordered Mesoporous Crystalline Titanium Oxides and Carbide/Carbon Composites

Low-temperature Synthesis of TiB2 Nanocrystals Using TiO2 ,LiBH4 and Mg

Synthesis of Anatase TiO2 Nanowires by Modifying TiO2 Nanoparticles Using the Microwave Heating Method

Preparation and Properties of CaTiO_3:Zn Nanoparticles Based on Sol-Gel Method

Rapid synthesis of high‐yield Ti3AlC2 MAX phase powders from TiC0.67 and Al with induction heating assistance

Accelerated sintering and phase transformation of TiO 2 in microwave radiation

Mechanochemically assisted synthesis of titanium carbonitride from metal and organic precursor

Microwave synthesis of BaTiO3 from BaCO3 and TiO 2

Preparation of Ti-coated Diamond Particles by Microwave Heating

Microwave heating and mechanism for seed-induced synthesis of SiC

Synthesis of Metal Oxide Nanoparticles by Rapid, High‐Temperature 3D Microwave Heating

Accelerated sintering and phase transformation of TiO2in microwave radiation

Synthesis and Characterization of TiC Nanofibers Obtained via a Modified Carbothermal Process