Abstract:It is of great significance for structural design and engineering evaluation to obtain the elastic–plastic parameters of materials. The inverse estimation of elastic–plastic parameters of materials based on nanoindentation technology has been applied in many pieces of research, but it has proved to be difficult to determine the elastic–plastic properties of materials by only using a single indentation curve. A new optimal inversion strategy based on a spherical indentation curve was proposed to obtain the elastoplastic parameters (the Young's modulus E, yield strength σy, and hardening exponent n) of materials in this study. A high-precision finite element model of indentation with a spherical indenter (radius R = 20 μm) was established, and the relationship between the three parameters and indentation response was analyzed using the design of experiment (DOE) method. The well-posed problem of inverse estimation under different maximum indentation depths (hmax1 = 0.06 R, hmax2 = 0.1 R, hmax3 = 0.2 R, hmax4 = 0.3 R) was explored based on numerical simulations. The results show that the unique solution with high accuracy can be obtained under different maximum press-in depths (the minimum error was within 0.2% and the maximum error was up to 1.5%). Next, the load-depth curves of Q355 were obtained by a cyclic loading nanoindentation experiment, and the elastic–plastic parameters of Q355 were determined by the proposed inverse-estimation strategy based on the average indentation load-depth curve. The results showed that the optimized load-depth curve was in good agreement with the experimental curve, and the optimized stress–strain curve was slightly different from the tensile test, and the obtained parameters were basically consistent with the existing research.

Measuring Material Plastic Properties with Optimized Representative Strain-Based Indentation Technique

Representative strain of indentation analysis

Limit analysis-based approach to determine the material plastic properties with conical indentation

An Energy-Based Method to Extract Plastic Properties of Metal Materials from Conical Indentation Tests

Analysis of Microindentation Unloading Curves based on Representative Strain Approach with Closed-Form Applications

Determining plastic properties of a material with residual stress by using conical indentation

Identification of Material Properties Using Indentation Test and Shape Manifold Learning Approach

Identification of plastic properties through spherical indentation

A Reverse Numerical Approach to Determine Elastic-plastic Properties of Multi-layer Material Systems with Flat Cylindrical Indenters

Can indentation technique measure unique elastoplastic properties?

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Further Investigation on the Definition of the Representative Strain in Conical Indentation

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Research on Determining Elastic–Plastic Constitutive Parameters of Materials from Load Depth Curves Based on Nanoindentation Technology

Identification of Anisotropic Plasticity Properties of Materials Using Spherical Indentation Imprint Mapping

Influence of Assumed Strain Hardening Relation on Plastic Stress-Strain Response Identification From Conical Indentation

An Insight into the Identifiability of Material Properties by Instrumented Indentation Test Using Manifold Approach Based on P-h Curve and Imprint Shape

Influence of Friction in Material Characterization in Microindentation Measurement.

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

Material characterization based on dual indenters

Effects of Yield Strength and Plastic Strain Exponent on Nanoindentation Process