Abstract:Electrospinning is a simple and straightforward process by which continuous polymer fibers with diameter ranging from a few nanometers to microns can be produced using an electrostatically driven jet of polymer solution(or polymer melt).In the present contribution,ultrafine fibers were spun from polyethylene oxide(PEO)/water solution using a homemade electrospinning set-up.The effects of the concentration of polymer solution and spinning voltage on the morphology of fibers and distribution of fiber diameters were investigated.A more comprehensive and systematic understanding of process parameters of the electrospinning was obtained.In this experiment fibers with diameter ranging from 100 nm to 1000 nm were obtained.The results showed that both the concentration of polymer solution and spinning voltage were important factors characterizing the morphology of fibers and distribution of fiber diameters.The concentration of polymer solution played an important role in the morphology of the fibers obtained.Lower concentration of polymer solution(0.04 kg/L PEO aqueous solution) tended to facilitate the formation of fibers with beads,and smooth and uniform fibers without beads were obtained at the concentration of 0.05 kg/L PEO aqueous solution and 0.06 kg/L PEO aqueous solution.As other process parameters were fixed,raising the concentration of polymer solution resulted in the increasing of average diameter of fibers.Spinning voltage also had an influence on the average diameter of fibers.Thinner fibers were received on the target with higher voltage applied on the nozzle at a given flow rate.The morphology of fibers electrospun from PEO was observed and analyzed by scanning electron microscopy(SEM).

Preparation of PVP/TEOS/Nitrates Composite Nanofibers

Study on electrospinnability of PVP/PEO composite micro-nano fibers

Preparation of PVP Helical Fibres by Electrospinning and Study on the Mechanism of Helix Formation

Preparation and Properties of Poly (vinyl Alcohol) Nanofibers by Electrospinning

Preparation of PVP/MEH-PPV Composite Polymer Fibers by Electrospinning and Study of Their Photoelectronic Character

Experimental Investigation of the Effect of Processing Parameters on the Formation of Electrospun Polyethylene Oxide Nanofibers

Preparation and Characterization of Poly(vinyl Pyrrolidone)/fe3o4 Composite Nanofibers

Fabrication of Polyvinylpyrrolidone/Boehmite Nanofibers by Electrospinning

Electrospinning preparation of Co_(0.5)Ni_(0.5)Fe_2O_4 nanofibers and its influencing factors

Controlling Poly(p-Phenylene Vinylene)/poly(vinyl Pyrrolidone) Composite Nanofibers in Different Morphologies by Electrospinning

Characterization of NiFe2O4 nanofibers prepared by electrospinning technique

Producing Pvp Nanofibers by Electrospinning in N-2

Influence of Solvents on the Formation of Ultrathin Uniform Poly(Vinyl Pyrrolidone) Nanofibers with Electrospinning

Preparation and Characterization of KGM/PVA Composite Nanofibrous Membranes

Preparation of Ultra-Fine Filament Non-Woven Composite Fabrics with Multi-Spinneret Electrospinning

Effect of polymer concentration and annealing temperature on TiO2-PVP composite nanofiber mats prepared with homemade electrospinning

Preparation and Characterization of ZrO2 Nanofibers and Nanobelts by Electrospinning

Polymer Nanofibers Prepared by Low-Voltage Near-Field Electrospinning

Synthesis of Poly(n-Vinylpyrrolidone)/β-cyclodextrin Composite Nanofibers Using Electrospinning Techniques

Structural evolution of electrospun composite fibers from the blend of polyvinyl alcohol and polymer nanoparticles.