Abstract:With an integrated resonance exciting heater and a self-sensing piezoresistor, resonant micro-cantilever bio/chemical sensors are optimally designed and fabricated by micromachining techniques. This study is emphasized on the optimization of the integrated heating resistor. Previous research has put the heater at either the cantilever clamp end, the midpoint or the free end. Aiming at sufficiently high and stable resonant amplitude, our research indicates that the optimized location of the thermal-electric exciting resistor is the clamp end instead of other positions. By both theoretical analysis and resonance experiments where three heating resistors are placed at the three locations of the fabricated cantilever, it is clarified that the clamp end heating provides the most efficient resonance excitation in terms of resonant amplitude, Q-factor and resonance stability. Besides, the optimized combination of dc bias and ac voltage is determined by both analysis and experimental verification. With the optimized heating excitation, the resonant cantilever is used for biotin-avidin-specific detection, resulting in a +/-0.1 Hz ultra-low noise floor of the frequency signal and a 130 fg mass resolution. In addition to resonance excitation, the heater is used to heat up the cantilever for speed-up desorption after detection that helps rapid and repeated sensing to chemical vapor. The clamp end is determined (by simulation) as the optimal heating location for uniform temperature distribution on the cantilever. Using the resonant cantilever, a rapid and repeated sensing experiment on dimethyl methylphosphonate (DMMP) vapor shows that a short-period heating at the detection interval significantly quickens the signal recovery and enhances the sensing repeatability.

Silicon microresonator arrays: A comprehensive study on fabrication techniques and pH-controlled stress-induced variations in cantilever stiffness

Detection of Ph Variation Using Modified Microcantilever Sensors

A Ph Sensor Based on a Microcantilever Coated with Intelligent Hydrogel

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

Fabrication and characterization of SiO2 microcantilever for microsensor application

Simulation and Fabrication of SiO2-based Piezoresistive Microbridges for Chem/biosensors

Fabrication of SiO $_{2}$ Microcantilever Using Isotropic Etching With ICP

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

A Piezoresistive Microcantilever Array for Surface Stress Measurement: Curvature Model and Fabrication

A hybrid polymer/ceramic/semiconductor fabrication platform for high-sensitivity fluid-compatible MEMS devices with sealed integrated electronics

Demonstration of Microcantilever-Based Sensor Array with Integrated Microfluidics

A Front-Side Released Single Crystalline Silicon Piezoresistive Microcantilever Sensor

A Micro-Machined Optical Fiber Cantilever As a Miniaturized Ph Sensor

Nano-Thickness Integrated Resonant Cantilevers With Surface-Stiffening Scheme For Ultra-Sensitive Detection Of Trace Chemicals

Micromechanical cantilever-based biosensors

Transient Deflection Response in Microcantilever Array Integrated with Polydimethylsiloxane (PDMS) Microfluidics.

A Sensor Platform Based On Piezoresistive Cantilever

Wafer-Scale Electroactive Nanoporous Silicon: Large and Fully Reversible Electrochemo-Mechanical Actuation in Aqueous Electrolytes

Chemical Sensors Based on Piezoresistive Cantilever Array

Resonant-cantilever bio/chemical sensors with an integrated heater for both resonance exciting optimization and sensing repeatability enhancement