Abstract:Soft pressure sensors play a significant role in developing "man-machine" tactile sensation in soft robotics and haptic interfaces. Specifically, capacitive sensors with micro-structured polymer matrices have been explored with considerable effort because of their high sensitivity, wide linearity range, and fast response time. However, the improvement of the sensing performance often relies on the structural design of the dielectric layer, which requires sophisticated microfabrication facilities. This article reports a simple and low-cost method to fabricate porous capacitive pressure sensors with improved sensitivity using the solvent evaporation-based method to tune the porosity. The sensor consists of a porous polydimethylsiloxane (PDMS) dielectric layer bonded with top and bottom electrodes made of elastic conductive polymer composites (ECPCs). The electrodes were prepared by scrape-coating carbon nanotubes (CNTs)-doped PDMS conductive slurry into mold-patterned PDMS films. To optimize the porosity of the dielectric layer for enhanced sensing performance, the PDMS solution was diluted with toluene of different mass fractions instead of filtering or grinding the sugar pore-forming agent (PFA) into different sizes. The evaporation of the toluene solvent allowed the fast fabrication of a porous dielectric layer with controllable porosities. It was confirmed that the sensitivity could be enhanced more two-fold when the toluene to PDMS ratio was increased from 1:8 to 1:1. The research proposed in this work enables a low-cost method of fabricating fully integrated bionic soft robotic grippers with soft sensory mechanoreceptors of tunable sensor parameters.

Fabrication of MOSFET Capacitive Sensor using Spray Coating Method

Sensitivity Enhancement of Soft Capacitive Pressure Sensors Using a Solvent Evaporation-Based Porosity Control Technique.

MOS interface control of high mobility channel materials for realizing ultrathin EOT gate stacks

Design and Application of a Metal Wet-Etching Post-Process for the Improvement of CMOS-MEMS Capacitive Sensors

Fabrication of SOI MEMS Inertial Sensors with Dry Releasing Process

Design and Fabrication of the Polyimide-Based Flexible MEMS Capacitive Tactile Force Sensor

CMOS-MEMS capacitive tactile sensor with vertically integrated sensing electrode array for sensitivity enhancement

Microwall array tactile sensor fabricated by transferring CNT/PDMS composite material into high aspect metal mold

CMOS Chip for Solid-State Tactile Force Sensor

The design and simulation of a MOSFET-based MEMS pressure sensor using an integrated simulation approach

Observation of MOSFET-like behavior of a TFT based on amorphous oxide semiconductor channel layer with suitable integration of atomic layered deposited high-k gate dielectrics

Integrated Piezoresistive Normal Force Sensors Fabricated Using Transfer Processes with Stiction Effect Temporary Handling

Post-Cmos Selective Electroplating Technique for the Improvement of Cmos-Mems Accelerometers

Fabrication of a Micromachined Capacitive Switch Using the CMOS-MEMS Technology

A tunable range/sensitivity CMOS-MEMS capacitive tactile sensor with polymer fill-in technique

Development of Wafer Level Process for the Fabrication of Advanced Capacitive Fingerprint Sensors Using Embedded Silicon Fan-Out (esifo(r)) Technology

The Method of Prevent Footing Effect in Making SOI Micro-Mechanical Structure

Vertically Integrated Multiple Electrode Design For Sensitivity Enhancement Of Cmos-Mems Capacitive Tactile Sensor

Vertical Integration of Force Transmission Structure on Capacitive Cmos-Mems Tactile Force Sensor for Sensitivity Improvement

Electric Modulation on the Sensitivity and Sensing Range of CMOS-MEMS Tactile Sensor by Using the PDMS Elastomer Fill-In

Flexible touch sensor fabricated by double-sided nanoimprint lithography metal transfer