Abstract:Good gas permeability is an essential factor for the smooth operation and high performance in the lower part of the blast furnace. Under the present low carbon blast furnace smelting conditions, the coke layer is thinner, and the proportion of the molten metal in the coke layer is significantly higher, resulting in a major reduction in gas permeability, which seriously affects blast furnace operations. Also, the lower thickness of the coke layer weakens the process of solid-liquid carbon dissolution when the molten iron passes through the coke layer, which reduces the carbon content of the molten iron and further deepens the erosion of the refractory by the unsaturated molten iron. The carbon dissolution in the molten iron in a blast furnace core was measured by a high-temperature vacuum wettability test tool that analyzed the interface wetting activity between Fe−C melts with specific carbon mass fraction (3.8%, 4.3%, 4.8%) and 99.9% of high temperatures graphite plates. Besides, the scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS) were used to analyze the graphite substrate’s carburizing morphology and carburizing distances. The results show that, with the increase of carbon content, the interface contact angle becomes bigger. The contact angle decreases with time, and eventually reaches a steady-state during the melting process, and the Fe−C melt with saturated carbon cannot be wet. The scanning electron microscopy analysis shows that a spherical cap-like depression is created by a cross-section of the Fe−C melt and the graphite substrate, and the radius and volume of the depression decrease with increasing carbon content. The study of the EDS scanning analysis shows that the amount of dissolved carbon atoms in the graphite substrate penetrates the Fe−C melt and decreases with increasing initial carbon concentration. The smaller the carburizing effect, the better the wetting is conducive to carbon mass transfer. It is found that by measuring carburizing of the carbon atoms in the graphite substrate into the Fe−C melt by calculating the surface energy reduces the surface energy between the two. Thus, the surface tension decreases and the melt spreads slowly with contact angle gradually decreasing during melting.

Dissection study of the deadman in a commercial blast furnace hearth

Graphitization and Performance of Deadman Coke in a Large Dissected Blast Furnace

Phase and Reaction Behavior of the Iron–Coke Interface Along the Coke-Free Area in a Dissected Blast Furnace Hearth

Deadman Behavior and Slag–Iron–Coke Interaction of Low Carbon and Safety Blast Furnace: A Review

Migration Behavior of K, Na, S, Ti in Hearth of a Commercial Blast Furnace

Numerical Simulation of Hot Metal Carbonization by Dead‐Man Coke in the Blast Furnace Hearth

Existence State and Structures of Extracted Coke and Accompanied Samples from Tuyere Zone of a Large-Scale Blast Furnace

A study on the characteristics of coke in the hearth of a superlarge blast furnace

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

“In situ” studies on cokes drilled from tuyere to deadman in a large-scale working blast furnace

Interface Wetting Behavior Between Iron and Coke During the Carbon Dissolution Process in a Blast Furnace

Study on Precipitation and Dissolution Mechanisms of Graphite in Hot Metal of Blast Furnace

Microstructure Analysis and Mineral Phase Transformation of Coke in Blast Furnace

Study on the High-Temperature Interaction between Coke and Iron Ores with Different Layer Thicknesses

Microstructure and Melting Loss Behavior of Blast Furnace Incoming Coke and Radial Tuyere Coke

Influence of the Residual Iron on the Erosion of Carbon Bricks in a 4000 m3 Blast Furnace Hearth: From the Measured Properties to the Proposed Mechanisms

Dynamic analysis of liquid permeability in the dripping zone of blast furnace and reaction behavior at the slag-coke interface

Effect of the coke particle size distribution on the burden layer porosity of blast furnace

Behavior of coke in the blast furnace for smelting Bayan Obo Mine

Online Deposition Measurement and Slag Bubble Behavior in the Reduction Zone of Pulverized Coal Staged Combustion

Occurrence State and Behavior of Carbon Brick Brittle in a Large Dissected Blast Furnace Hearth