Abstract:In this study, the effect of the cell density of monolithic catalysts was investigated and further mathematically modeled on cordierite supports used in CO 2 methanation. Commercial cordierite monoliths with 200, 400, and 500 cpsi cell densities were coated by immersion into an ethanolic suspension of Ni/CeO 2 active phase. SEM–EDS analysis confirmed that, owing to the low porosity of cordierite (surface area < 1 m 2 g −1 ), the Ni/CeO 2 diffusion into the walls was limited, especially in the case of low and intermediate cell density monoliths; thus, active phase was predominantly loaded onto the channels' external surface. Nevertheless, despite the larger exposed surface area in the monolith with high cell density, which would allow for better distribution and accessibility of Ni/CeO 2 , its higher macro-pore volume resulted in some introduction of the active phase into the walls. As a result, the catalytic evaluation showed that it was more influenced by increments in volumetric flow rates. The low cell density monolith displayed diffusional control at flow rates below 500 mL min −1 . In contrast, intermediate and high cell density monoliths presented this behavior up to 300 mL min −1 . These findings suggest that the interaction reactants-catalyst is considerably more affected by a forced non-uniform flow when increasing the injection rate. This condition reduced the transport of reactants and products within the catalyst channels and, in turn, increased the minimum temperature required for the reaction. Moreover, a slight diminution of selectivity to CH 4 was observed and ascribed to the possible formation of hot spots that activate the reverse water–gas shift reaction. Finally, a mathematical model based on fundamental momentum and mass transfer equations coupled with the kinetics of CO 2 methanation was successfully derived and solved to analyze the fluid dynamics of the monolithic support. The results showed a radial profile with maximum fluid velocity located at the center of the channel. A reactive zone close to the inlet was obtained, and maximum methane production (4.5 mol m −3 ) throughout the monolith was attained at 350 °C. Then, linear streamlines of the chemical species were developed along the channel.

Investigation of CO methanation activities of ZSM-5 supported Ni catalysts using microchannel and conventional reactor

Solvents Molecular Mobility in Coked Catalyst ZSM-5 Studied by NMR Relaxation and Pulsed Field Gradient Techniques

CO<sub>2</sub> methanation over Ni/ZSM-5 catalysts: The effects of support morphology and La<sub>2</sub>O<sub>3</sub> modification

Investigating the Effect of Ni Loading on the Performance of Yttria-Stabilised Zirconia Supported Ni Catalyst during CO2 Methanation

Efficient and Stable Ni/ZSM-5@MCM-41 Catalyst for CO 2 Methanation

CO2 methanation over Ni/ZSM-5 catalysts: The effects of support morphology and La2O3 modification

CO2 Methanation over the Ni-based Catalysts Supported on the Hollow ZSM-5 Zeolites: Effects of the Hollow Structure and Alkaline Treatment

Balance effect between Ni dispersion and hydrophobicity in CO 2 methanation over Ni/ZSM-5

Catalytic Methanation of Syngas over Ni-based Catalysts with Different Supports

Catalytic Performance for CO Methanation over Ni/MCM-41 Catalyst in a Slurry-Bed Reactor

Total methanation of syngas to synthetic natural gas over Ni catalyst in a micro-channel reactor

Insights into the Zn Promoter for Improvement of Ni/SiO 2 Catalysts Prepared by the Ammonia Evaporation Method toward CO 2 Methanation

CO2 Methanation over Nickel-Based Catalysts Supported on MCM-41 with in Situ Doping of Zirconium

Study on CO2 reforming of methane to syngas over Al 2O3-ZrO2 supported Ni catalysts prepared via a direct sol-gel process

Improved Catalytic Performance of Ni Catalysts for Steam Methane Reforming in a Micro-Channel Reactor

Insight and comprehensive study of Ni-based catalysts supported on various metal oxides for CO2 methanation

An active and stable nickel-based catalyst with embedment structure for CO2 methanation

Catalytic combustion of methane, methanol, and ethanol in microscale combustors with Pt/ZSM-5 packed beds

Modeling and experimental analysis of CO2 methanation reaction using Ni/CeO2 monolithic catalyst

Insights on the Highly Stable and Coke-Resistant Nickel/Zirconia Nanocatalyst for the Methanation of Carbon Dioxide

Influence of framework Al distribution in HZSM-5 channels on catalytic performance in the methanol to propylene reaction