Abstract:Silicon Photomultipliers (SiPMs) are photon-counting detectors with great potential to improve the sensitivity of optical receivers. Recent studies of SiPMs in communication focus on the speed rather than the power consumption of the receiver. The gain bandwidth product (GBP) of the amplifiers in these post-SiPM readout circuits is significantly higher than the target data rate. Additionally, the SiPM experiments for optical communication are performed using an offline method which uses instruments including oscilloscopes and personal computers to process chunks of the transmitted data. In this work, we have developed an embedded real-time field-programmable gate array (FPGA) based system to evaluate a commercially available 1 mm-sq SiPM. The implemented real-time system achieves data rates from 10 kbps to 1 Mbps with a bit error rate (BER) below 1E-3 approaching the Poisson limit. Results showed that reducing either the dark count rate or increasing the data rate leads to lower dark counts per bit time, hence less power penalty to maintain a probability of error (PE) of 1E-3. The numerically simulated results indicated that to maintain the Poisson limit, the minimum GBP of the amplifier in the post-SiPM readout circuit is 120 MHz based on the proposed setup within the tested data rates. This GBP limitation is determined by the noise floor of the read-out circuit. The analysis of the minimum GBP and electrical power consumption of the receiver in photon counting and BER enables the potential future adoption of this receiver technology when high optical sensitivity is required, such as visible light communications (VLC) for low data rate Internet of Things (IoT) applications.

Design and performance test of pulse X-ray receiver based on LYSO-SiPM for X-ray communication

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

Experimental Analysis of Thz Receiver Performance in 80 Gbit/S Communication System

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

SIPAM-4 scheme improves bit error rate performance in MISO X-ray communication system

X-ray transmission effects in a high-density dynamic-dusty plasma environment

Photonic Radiofrequency Receiver Utilizing a Phase Modulator and a Tunable Single Sideband Optoelectronic Oscillator

Performance analysis and experimental verification of SPAD receivers without photon counting for optical wireless communications

Pulse-laser Based Long-range NLOS Ultraviolet Communication: Pulse Response Position Estimation and Frame Synchronization optimization

A Novel Visible Light Communication System Prototype Based on SiPM Receiver

Design and Performance of 1.25gb/s AC-coupled Burst-mode Optical Receiver

Performance Evaluation of the Chinese JOINBON SiPM for Radiation Detection Systems

X-Ray Characteristics of Four-Level Pulse Amplitude Modulation for X-Ray Communication Based on Carbon Nanotube Cold Cathode X-Ray Source

Design and Fabrication of Short Wavelength Monolithically Integrated Optical Receiver Front End

Implementation of a high photon efficiency optical receiver using a semiconductor optical amplifier

A superconducting nanowire photon number resolving four-quadrant detector-based Gigabit deep-space laser communication receiver prototype

Design and Evaluation of a High-Sensitivity Digital Receiver with the Finite Impulse Response Filter Algorithm for Free-Space Laser Communication

Design Of 56 Gb/Spam4 Wire-Line Receiver With Ring Vco Based Cdr In A 65 Nm Cmos Technology

Design of 80-Gb/s PAM4 Wireline Receiver in 65-Nm CMOS Technology

Implementation and Evaluation of SiPM-Based Photon Counting Receiver for IoT Applications