Chapter 2 – Extrinsic Fabry-perot Interferometer Measuring Magnetic Field a Typical Efpi Sensor Configuration Is Shown in Figure 2.1. the Light from a Laser Source

Abstract:The Fabry-Perot interferometer consists of two parallel reflectors separated by a fixed distance. A monochromatic optical wave incident upon an etalon at an arbitrary angle to the normal of the mirror (semi transparent reflector) will experience multiple reflections within the mirrors. The intensity distribution of the reflected and refracted interfering beams using an etalon generates a set of fringes for each case. The distance of interfering peak or bottom of the fringe is dependent on the spacing between the etalon mirrors and the inverse wavelength of the light. Hence, the basic function of the F-P interferometer is to transform wavelength into an displacement. The main advantages of F-P interferometers based on optical fiber over the other sensor configurations such as Michelson, Mach-Zehnder, and Sagnac interferometers are lightness and compactness, high reliability, low cost, and ease in fabrication. Hence optical fiber based Fabry-Perot (F-P) sensors have been used for measuring temperature, strain, vibration, acoustic waves, and magnetic fields. The measurement of voltage and pressure were done by using an etalon based F-P configuration [2.1]. Beside this classic etalon based configuration, there are several ways to fabricate the Fabry-Perot cavity such as using Bragg gratings in or on the fiber [2.2], and air-glass interfaces at the fiber ends as the reflectors [2.3]. An etalon sensor was fabricated in a continuous length of fiber by a pair of semireflective splices [2.4]. In this case, the optical wave resides inside the fiber so that the sensing mechanism is intrinsic. The F-P sensors based on air-glass reflectors are referred to as the extrinsic F-P interferometers (EFPI). The extrinsic Fabry-Perot interferometer does not have the polarization rotation problem which is inherent in intrinsic F-P interferometer since the light leaves air-glass interface and reflected back through the air gap between the reflectors. Hence the EFPI configuration is suitable for measuring a low exturbance.
Physics
What problem does this paper attempt to address?