Abstract:We present two prototypes of a gigabit transceiver ASIC, GBCR1 and GBCR2, both designed in a 65-nm CMOS technology for the ATLAS Inner Tracker Pixel Detector readout upgrade. The first prototype, GBCR1, has four upstream receiver channels and one downstream transmitter channel with pre-emphasis. Each upstream channel receives the data at 5.12 Gbps through a 5 meter AWG34 Twinax cable from an ASIC driver located on the pixel module and restores the signal from the high frequency loss due to the low mass cable. The signal is retimed by a recovered clock before it is sent to the optical transmitter VTRx+. The downstream driver is designed to transmit the 2.56 Gbps signal from lpGBT to the electronics on the pixel module over the same cable. The peak-peak jitter (throughout the paper jitter is always peak-peak unless specified) of the restored signal is 35.4 ps at the output of GBCR1, and 138 ps for the downstream channel at the cable ends. GBCR1 consumes 318 mW and is tested. The second prototype, GBCR2, has seven upstream channels and two downstream channels. Each upstream channel works at 1.28 Gbps to recover the data directly from the RD53B ASIC through a 1 meter custom FLEX cable followed by a 6 meter AWG34 Twinax cable. The equalized signal of each upstream channel is retimed by an input 1.28 GHz phase programmable clock. Compared with the signal at the FLEX input, the additional jitter of the equalized signal is about 80 ps when the retiming logic is o . When the retiming logic is on, the jitter is 50 ps at GBCR2 output, assuming the 1.28 GHz retiming clock is from lpGBT. The downstream is designed to transmit the 160 Mbps signal from lpGBT through the same cable connection to RD53B and the jitter is about 157 ps at the cable ends. GBCR2 consumes about 150 mW when the retiming logic is on. This design was submitted in November 2019.

A 4.25-Gbps serializer ASIC in 180 nm for the monolithic active pixel sensor of the NICA-MPD inner tracker system

A 5.12-Gbps serializer circuit for front-end fast readout electronics of silicon pixelated detectors

A 1.2 Gbps Failsafe Low Jitter LVDS Transmitter-Receiver Applied in CMOS Image Sensor.

Design Realization and Characterization of A Position Sensitive Detector for Fast Optical Measurement

A Low-Power, Low-Latency, Dual-Channel Serializer ASIC for Detector Front-End Readout

Characterization of a gigabit transceiver for the ATLAS inner tracker pixel detector readout upgrade

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

A 3.2-Gb/s Serial Link Transmitter in 0.18μm CMOS Technology for CMOS Monolithic Active Pixel Sensors Application

Monolithic MHz-frame rate digital SiPM-IC with sub-100 ps precision and 70$~μ$m pixel pitch

Development of A 16:1 serializer for data transmission at 5 Gbps

Monolithic MHz-frame rate digital SiPM-IC with sub-100 ps precision and 70 μm pixel pitch

Characterization of a Serializer ASIC Chip for the Upgrade of the ATLAS Muon Detector

A 20 Gbps PAM4 VCSEL Driving ASIC for Detector Front-End Readout

Prototype design of a Monolithic Active Pixel Sensor for the Electron-ion collider in China

A Fast Front-end Readout Design for NICA-MPD Shashlik Electromagnetic Calorimeter

Design and Testing of a 0.8 V Low-voltage High-rate Prototype Readout ASIC for the Micro-Pattern Gas Detector

Development of a Multi-Channel ASIC with Individual Energy and Timing Digitization for SiPM Detectors for TOF-PET Applications

1.28 and 5.12 Gbps multi-channel twinax cable receiver ASICs for the ATLAS Inner Tracker Pixel Detector Upgrade

A 20 Gbps PAM4 Data Transmitter ASIC for Particle Physics Experiments

Characterization of the CMS Endcap Timing Layer Readout Chip Prototype with Charge Injection

20 ps Time Resolution with a Fully-Efficient Monolithic Silicon Pixel Detector without Internal Gain Layer