Abstract:Due to the capability of CO2 uptake and the high theoretical energy density, Li-CO2 batteries have attracted a great deal of attention as a novel and promising energy storage system which is based on the reversible reaction between lithium and CO2. However, the insulating Li2CO3 formed upon the discharge process, which is difficult to be decomposed during recharge process due to the lack of effective cathode catalyst, leads to the poor cycling performance and huge overpotential of the Li-CO2 batteries. In this work, the Ru nanosheets were directly grown on one side of the three-dimensional nickel foam through a galvanic replacement reaction to form the Ru/Ni electrode, which was further used in the Li-CO2 batteries. The highly dispersed Ru nanosheets in the Ru/Ni cathode effectively promote the decomposition of discharge product Li2CO3 and thus reduce the charge overpotential. Moreover, the typical porous and binder-free Ru/Ni electrode not only has a sturdy construction to suppress the side reaction in the Li-CO2 batteries, but also enables the rapid permeation of CO2 and electrolyte/electron into the active sites of the Ru/Ni electrode. As a result, the Ru/Ni cathode-based Li-CO2 battery exhibits the superior discharge capacity (9502 mAh g(-1)), good coulombic efficiency (95.4%) and excellent rate performance (3177mAh g(-1) at 500mA g(-1)) at the full discharge/charge condition. When operated at the limited capacity of 1000mAh g(-1), this cell can run for over 100 cycles with the charge potential below 4.1 V. The findings provide a snapshot towards improving the reversibility of Li-CO2 batteries by designing the binder-free stable cathodes. (C) 2019 Elsevier Ltd. All rights reserved.

A rechargeable all-solid-state Li–CO 2 battery using a Li 1.5 Al 0.5 Ge 1.5 (PO 4 ) 3 ceramic electrolyte and nanoscale RuO 2 catalyst

A rechargeable all-solid-state Li-CO<sub>2</sub> battery using a Li<sub>1.5</sub>Al<sub>0.5</sub>Ge<sub>1.5</sub>(PO<sub>4</sub>)<sub>3</ sub> ceramic electrolyte and nanoscale RuO<sub>2</sub> catalyst

A Design of Solid-State Li-S Cell with Evaporated Lithium Anode to Eliminate Shuttle Effects.

Effective Ru/CNT Cathode for Rechargeable Solid-State Li–CO 2 Batteries

Intensive Investigation on All-Solid-state Li-air Batteries with Cathode Catalysts of Single-Walled Carbon Nanotube/ruo2

A reversible lithium–CO2 battery with Ru nanoparticles as a cathode catalyst

Enhanced Electrochemical Performance of Aprotic Li‐CO 2 Batteries with a Ruthenium‐Complex‐Based Mobile Catalyst

Graphdiyne scaffold anchored highly dispersed ruthenium nanoparticles as an efficient cathode catalyst for rechargeable Li–CO2 battery

Ultrafine Ru nanoparticles anchored on N-doped mesoporous hollow carbon spheres as a highly efficient bifunctional catalyst for Li–CO 2 batteries

A Highly Reversible Long-Life Li-CO 2 Battery with a RuP 2 -Based Catalytic Cathode.

A Highly Reversible Long-Life Li-CO2 Battery with a RuP2-Based Catalytic Cathode

A reversible lithium–CO<sub>2</sub> battery with Ru nanoparticles as a cathode catalyst

Ru Nanosheet Catalyst Supported by Three-Dimensional Nickel Foam As a Binder-Free Cathode for Li–CO2 Batteries

Ru/ITO: a Carbon-Free Cathode for Nonaqueous Li-O2 Battery.

An ultralow-charge-overpotential and long-cycle-life solid-state Li-CO2 battery enabled by plasmon-enhanced solar photothermal catalysis

Nanoporous Ru as a carbon- and binder-free cathode for Li-O2 batteries.

Spatially Confined Sub-Nanometer Pt in RuO2 Nanosheet As Robust Bifunctional Oxygen Electrocatalyst for Stabilizing Li-O2 Batteries

Decreasing the Overpotential of Aprotic Li‐CO2 Batteries with the In‐Plane Alloy Structure in Ultrathin 2D Ru‐Based Nanosheets

Garnet-type oxide electrolyte with novel porous-dense bilayer configuration for rechargeable all-solid-state lithium batteries

High-Performance Li-CO2 Battery Based on Carbon-Free Porous Ru@QNFs Cathode.

Cationic metal-organic framework derived ruthenium-copper nano-alloys in porous carbon to catalytically boost the cycle life of Li-CO2 batteries