Abstract:Cement clinkers containing mainly belite (β-C2S as a model crystal), replacing alite, offer a promising solution for the development of environmentally friendly solutions to reduce the high level of CO2 emissions in the production of Portland cement. However, the much lower reactivity of belite compared to alite limits the widespread use of belite cements. Therefore, this work presents a fundamental atomistic computational approach for comprehending and quantifying the mesoscopic forward dissolution rate of β-C2S, applied to two reactive crystal facets of (100) and (1 ̄00). For this, an atomistic kinetic Monte Carlo (KMC) upscaling approach for cement clinker was developed. It was based on the calculated activation energies (ΔG*) under far-from-equilibrium conditions obtained by a molecular dynamic simulation using the combined approach of ReaxFF and metadynamics, as described in the Part 1 paper in this Special Issue. Thus, the individual atomistic dissolution rates were used as input parameters for implementing the KMC upscaling approach coded in MATLAB to study the dissolution time and morphology changes at the mesoscopic scale. Four different cases and 21 event scenarios were considered for the dissolution of calcium atoms (Ca) and silicate monomers. For this purpose, the (100) and (1 ̄00) facets of a β-C2S crystal were considered using periodic boundary conditions (PBCs). In order to demonstrate the statistical nature of the KMC approach, 40 numerical realizations were presented. The major findings showed a striking layer-by-layer dissolution mechanism in the case of an ideal crystal, where the total dissolution rate was limited by the much slower dissolution of the silicate monomer compared to Ca. The introduction of crystal defects, namely cutting the edges at two crystal boundaries, increased the overall average dissolution rate by a factor of 519.

Mechanical and dynamical stability of major oxide constituents of Portland cement clinker: a density functional theory study

Mechanical and dynamical stability of major oxide constituents of Portland cement clinker: a density functional theory study

Elastic and thermodynamic properties of the major clinker phases of Portland cement: Insights from first principles calculations

Electronic, elastic properties and thermal conductivity of the major clinker phases of portland cement: Insights from first-principles calculations

Fundamental Mechanical Behavior of CMMOSC-S-C Composite Stabilized Marine Soft Clay

Understanding why Alite is responsible of the main mechanical characteristics in Portland cement

Fundamental Discrepancy of Chemical Reactivity of Tricalcium Oxy Silicate (alite), Dicalcium Silicate (Belite), and Their Polymorphs: A Density Functional Theory Study

Probing the exact form and doping preference of magnesium in ordinary Portland cement clinker phases: A study from experiments and DFT simulations

Revealing the solid solution tendency of tungsten ions in phases of Ordinary Portland cement clinker: A study based on experiments and DFT calculations

Thermal conductivity of Portlandite: Molecular dynamics based approach

A kinetic Monte Carlo study of the C 3 S dissolution mechanism

Dissolution of β-C2S Cement Clinker: Part 1 Molecular Dynamics (MD) Approach for Different Crystal Facets

Influence of (al, Fe, Mg) Impurities on Triclinic Ca3SiO5: Interpretations from DFT Calculations

Dissolution of β-C2S Cement Clinker: Part 2 Atomistic Kinetic Monte Carlo (KMC) Upscaling Approach

The physics of cement cohesion

Dissolution of Portlandite in Pure Water: Part 2 Atomistic Kinetic Monte Carlo (KMC) Approach

Combining Raman Spectroscopy, DFT Calculations, and Atomic Force Microscopy in the Study of Clinker Materials

Chemical Bonding, Electronic Properties, Mechanical Strength, and Thermal Conductivity of Cement Compounds by First-Principles Study

Revealing the substitution preference of zinc in ordinary Portland cement clinker phases: A study from experiments and DFT calculations

A realistic molecular model of cement hydrates

Unraveling the doping preference of zinc ions in sulfoaluminate cement clinker minerals: A study combining experiments and DFT calculations