Abstract:Density functional theory (DFT) simulation has been recently introduced to understand the doping behavior of impurities in clinker phases. P-doped ye'elimite, a typical doping clinker phase, tends to form when phosphogypsum is used to manufacture calcium sulfoaluminate cement (CSA) clinkers. However, the substitution mechanism of P has not been uncovered yet. In this study, the influence of different doping amounts of P on the crystalline and electronic structure of ye'elimite was investigated using backscattered scanning electron microscopy-energy X-ray dispersive spectroscopy, X-ray diffraction tests, Rietveld quantitative phase analysis, and DFT simulations. Furthermore, the substitution preference of P in ye'elimite was revealed. Our results showed that increasing the doping amount of P increased the impurity contents in CSA clinkers, transforming the ye'elimite crystal system from the orthorhombic to the cubic system and decreasing the interplanar spacing of ye'elimite. Based on the calculation results of the defect formation energies, additional energies were required for P atoms to substitute Ca/Al atoms compared with those required for P atoms to substitute S atoms in both orthorhombic and cubic systems of ye'elimite. Combined calculation results of the bond length-bond order and partial density of states showed that the doped P atoms preferably substituted S atoms; the second possible substituted atoms were Al atoms, while there was only a slight possibility for substitution of Ca atoms. The substitution of P atoms for S atoms can be verified based on the elemental distribution in P-doped ye'elimite and the increasing residual CaSO4 contents. The transition of the crystal system and a decrease in the interplanar spacing for ye'elimite can also prove that the substitution of P atoms for Al atoms occurred substantially.

Probing the exact form and doping preference of magnesium in ordinary Portland cement clinker phases: A study from experiments and DFT simulations

Revealing the substitution preference of zinc in ordinary Portland cement clinker phases: A study from experiments and DFT calculations

Structural and Mechanical Properties of Doped Tobermorite

Exploring Mechanisms of Hydration and Carbonation of MgO and Mg(OH)2 in Reactive Magnesium Oxide-based Cements

Understanding the zinc incorporation into silicate clinker during waste co-disposal of cement kiln: A density functional theory study

Solidification/stabilisation behaviours of Zn2+ in magnesium potassium phosphate cement: Experiments and density functional theory study

Revealing the solid solution tendency of tungsten ions in phases of Ordinary Portland cement clinker: A study based on experiments and DFT calculations

Unraveling the doping preference of zinc ions in sulfoaluminate cement clinker minerals: A study combining experiments and DFT calculations

Effect of K+ Diffusion on Hydration of Magnesium Potassium Phosphate Cement with Different Mg/P Ratios: Experiments and Molecular Dynamics Simulation Calculations

Study on microstructural evolutions and properties of the magnesium oxysulfate cement in the initial curing processes

Characterization of magnesium-calcium oxysulfate cement prepared by replacing MgSO4 in magnesium oxysulfate cement with untreated desulfurization gypsum

Influence of Mineral Admixtures on the Properties of Magnesium Oxychloride Cement Lean Concrete

Fractal Analysis on Pore Structure and Hydration of Magnesium Oxysulfate Cements by First Principle, Thermodynamic and Microstructure-Based Methods

Mechanical and dynamical stability of major oxide constituents of Portland cement clinker: a density functional theory study

The influence of point defects on the sintering of magnesium oxide

Phosphorus Substitution Preference in Ye'elimite: Experiments and Density Functional Theory Simulations

Microstructure and micromechanical properties of magnesium phosphate cement

Effects of Dolomitic Limestone on the Properties of Magnesium Oxysulfate Cement

Effect of MgO/ZnO ratio on the formation process of MgxZn1-xO ceramics

Study on the Stability of Low-Carbon Magnesium Cementitious Materials in Sulfate Erosion Environments