Abstract:Diesel engine emissions for on-road, stationary and marine applications are regulated in the United States via standards set by the Environmental Protection Agency (EPA). A major component of diesel exhaust that is difficult to reduce is nitrogen oxides (NOx). Selective catalytic reduction (SCR) has been in use for many years for stationary applications, including external combustion boilers, and is promising for NOx abatement as a retrofit for mobile applications where diesel compression ignition engines are used. The research presented in this paper is the first phase of a program focused on the reduction of NOx by use of a stand-alone urea injection system, applicable to marine diesel engines typical of work boats (e.g., tugs). Most current urea SCR systems communicate with engine controls to predict NOx emissions based on signals such as torque and engine speed, however many marine engines in use still employ mechanical injection technology and lack electronic communication abilities. The system developed and discussed in this paper controls NOx emissions independentof engine operating parameters and measures NOx and exhaust flow using the following exhaust sensor inputs: absolute pressure, differential pressure, temperature, and NOx concentration. These sensor inputs were integrated into an independent controller and open loop architecture to estimate the necessary amount of urea needed, and the controller uses pulse width modulation (PWM) to power an automotive fuel injector for airless urea delivery. The system was tested in a transient test cell on a 350 hp engine certified at 4 g/bhp-hr of NOx, with a goal of reducing the engine out NOx levels by 50%. NOx reduction capabilities of 41-67% were shown on the non road transient cycle (NRTC) and ICOMIA E5 steady state cycles with system optimization during testing to minimize the dilute ammonia slip to cycle averages of 5-7 ppm. The goal of 50% reduction of NOx can be achieved dependent upon cycle. Further research with control optimization, urea distribution and possible use of oxidation catalysts is recommended to improve the NOx reduction capabilities while minimizing ammonia slip.

Development of Map based Open Loop Control Algorithm for Urea - SCR System

Robust, Model-Based Urea Dosing Control for SCR Aftertreatment Systems using a Cross-Sensitive Tailpipe NOx Sensor

Improvement of NOX Reduction Rate of Urea SCR System Applied for an Non-Road Diesel Engine

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

Model-based urea injection control strategy and ammonia storage estimation for diesel engine SCR system

Model-based Closed-loop Control of Urea SCR Exhaust Aftertreatment System for Diesel Engine

Model Predictive Control Case Study: Selective Catalytic Reduction (scr) System in Coal-Fired Power Plant

Experimental investigation of urea injection strategy for close-coupled SCR aftertreatment system to meet ultra-low NO<i><sub>x</sub></i> emission regulation

Model-Based Estimation and Control System Development in a Urea-SCR Aftertreatment System

Study of Control Strategy for Urea-SCR After-Treatment System of Heavy Duty Diesel Engine

Closed-Loop Control Strategy and State Estimator for Diesel Engine SCR After-Treatment System

A fuzzy logic urea dosage controller design for two-cell selective catalytic reduction systems

Model Predictive Control: A Unified Approach for Urea-Based SCR Systems

Urea injection control strategy in urea-selective catalytic reduction for heavy-duty diesel engine under transient process

Nonlinear Model Predictive Control of Integrated Diesel Engine and Selective Catalytic Reduction System for Simultaneous Fuel Economy Improvement and Emissions Reduction

Ammonia coverage ratio control of a novel two-cell SCR-DeNOX system configuration based on IA-ISMC

Experimental demonstration of NOx reduction and ammonia slip for diesel engine SCR system

Review on Selective Catalytic Reduction Technology of Diesel Engines

Design and testing of an independently controlled urea SCR retrofit system for the reduction of NOx emissions from marine diesels

Fuel Consumption and Emission Reduction for Non-Road Diesel Engines with Electrically Heated Catalysts

Modelling and control of urea-SCR systems through the triple-step non-linear method in consideration of time-varying parameters and reference dynamics