α-(Al x Ga 1−x ) 2 O 3 single-layer and heterostructure buffers for the growth of conductive Sn-doped α-Ga 2 O 3 thin films via mist chemical vapor deposition

Giang T. Dang,Shota Sato,Yuki Tagashira,Tatsuya Yasuoka,Li Liu,Toshiyuki Kawaharamura
DOI: https://doi.org/10.1063/5.0023041
IF: 6.6351
2020-10-01
APL Materials
Abstract:A third generation mist chemical vapor deposition (3rd G mist CVD) system was used to grow six single-layer and two heterostructure <i>α</i>-(Al<sub>x</sub>Ga<sub>1−x</sub>)<sub>2</sub>O<sub>3</sub> buffers on <i>c</i>-plane sapphire substrates for the subsequent deposition of conductive Sn-doped <i>α</i>-Ga<sub>2</sub>O<sub>3</sub> (Sn:<i>α</i>-Ga<sub>2</sub>O<sub>3</sub>) thin films. In the six single-layer buffers, the Al contents <i>x</i> increased from 0 to 0.66. The two heterostructure buffers consisted of six ∼20-nm- and ∼100-nm-thick layers laying on top of each other. The 3rd G mist CVD system enabled the growth of these complicated multi-layer heterostructures in a single run, while mono-crystallinity was still maintained in all grown layers. Strain was observed in the 20-nm heterostructure, while the layers in the 100-nm heterostructure almost fully relaxed and the Vegard's law was followed even when the <i>α</i>-(Al<sub>x</sub>Ga<sub>1−x</sub>)<sub>2</sub>O<sub>3</sub> layers were stacked on each other. Transmission electron microscopy analyses show that the dislocation densities remained high in the order of 10<sup>10</sup> cm<sup>−2</sup> despite the employment of the buffers. PtO<sub>x</sub> and AgO<sub>x</sub> Schottky diodes (SDs) were fabricated on the Sn:<i>α</i>-Ga<sub>2</sub>O<sub>3</sub> films. The barrier height vs ideality factor plots could be fitted by linear dependences, indicating that the large ideality factors observed in <i>α</i>-Ga<sub>2</sub>O<sub>3</sub> SDs could be explained by the inhomogeneity of the SDs. The extrapolation of the dependences for the PtO<sub>x</sub> and AgO<sub>x</sub> SDs yielded homogeneous Schottky barrier heights of ∼1.60 eV and 1.62 eV, respectively, suggesting that the Fermi level was pinned at the <i>E</i><sub><i>c</i></sub> − 1.6 eV level. The Sn:<i>α</i>-Ga<sub>2</sub>O<sub>3</sub> film grown on the strained 20-nm heterostructure buffer showed best characteristics overall.
materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology
What problem does this paper attempt to address?