Abstract:A proton exchange membrane (PEM) fuel cell is one of the highly efficient hydrogen utilization devices. However, due to the complex physical and chemical processes in fuel cells, developing a mathematical model of the PEM fuel cell is challenging. In this study, a new coupled model based on the computational fluid dynamics method and a 1D model is proposed for the accurate and fast prediction of PEM fuel cell performance. First of all, the proposed model is validated using the literature data. It is then applied to simulate the distribution and evolution of the current density, hydrogen and oxygen mass fraction, and membrane water content in catalyst layer (CL). Results show that the increase in the current density is attributed to the increase in the consumption rate of hydrogen and oxygen and the increase in the membrane water content. In addition, the stabilized supply of the oxygen in cathode and the membrane water content in the anode CL are critical for the improvement of the fuel cell performance. For the cases studied in this research, when the output voltage decreases from 0.6 V to 0.3 V, the current density increases from 5738.1 A/m2 to 15171.2 A/m2. The average oxygen mass fraction in the cathode CL and the average membrane water content in the anode CL decreased by 42.3 % and 9.6 %, respectively. In addition, when the fuel cell starts up at 0.6 V, the concentration of hydrogen and oxygen drops gradually decreases along the flow direction of the CL, while the membrane water content rapidly increases initially, and then increases slowly, with the turning point around at approximately 2.2 x 10-3 m. Under the combined effect of hydrogen and oxygen concentration, as well as the membrane water content, the current density first increases and then decreases, with the maximum value exceeding 6500 A/m2.

A current density distribution reconstruction method in proton exchange membrane fuel cell from external magnetic field based on convolutional neural network

Three-dimensional multi-field digital twin technology for proton exchange membrane fuel cells

Design and Modelling of 3D Bionic Cathode Flow Field for Proton Exchange Membrane Fuel Cell

Multidimensional Modelling Of Polymer Electrolyte Fuel Cells Under A Current Density Boundary Condition

A Coupled CFD Model for an Accurate and Fast Prediction of the Unsteady Operation Process of a Proton Exchange Membrane Fuel Cell

Current density and temperature distribution measurement and homogeneity analysis for a large-area proton exchange membrane fuel cell

A Hybrid Health Prognostics Method For Proton Exchange Membrane Fuel Cells With Internal Health Recovery

Diagnosing Improper Membrane Water Content in Proton Exchange Membrane Fuel Cell Using Two-Dimensional Convolutional Neural Network

Experimental investigation of stable the proton exchange membrane fuel cell control using magnetic sensor probes

An Artificial Neural Network Ensemble Method for Fault Diagnosis of Proton Exchange Membrane Fuel Cell System

Performance evaluation on full-scale proton exchange membrane fuel cell: Mutual validation of one-dimensional, three-dimensional and experimental investigations

Numerical Modeling and Performance Prediction of Water Transport for PEM Fuel Cell

Model-based estimation of liquid saturation in cathode gas diffusion layer and current density difference under proton exchange membrane fuel cell flooding

Study of Internal Multi-Parameter Distributions of Proton Exchange Membrane Fuel Cell with Segmented Cell Device and Coupled Three-Dimensional Model

Simulation of Water Transport in Proton Exchange Membrane Fuel Cell Using a One-dimension Model

Improvement of the three-dimensional fine-mesh flow field of proton exchange membrane fuel cell (PEMFC) using CFD modeling, artificial neural network and genetic algorithm

Data-driven Fault Diagnosis for PEM Fuel Cell System Using Sensor Pre-Selection Method and Artificial Neural Network Model

Three-dimensional Modeling of Transport Phenomena in Proton Exchange Membrane Fuel Cell with Different Fluid Channel

AI-assisted proton exchange membrane (PEM) fuel cell performance prediction using CFD and data-driven surrogate models

A 1 + 1-D Multiphase Proton Exchange Membrane Fuel Cell Model for Real-Time Simulation

Investigation of the non-uniform distribution of current density in commercial-size proton exchange membrane fuel cells