Abstract:Purpose: To report on experimental results of a high spatial resolution silicon-based detector exposed to therapeutic quality proton beams in a 0.95 T transverse magnetic field. These experimental results are important for the development of accurate and novel dosimetry methods in future potential real-time MRI-guided proton therapy systems. Methods: A permanent magnet device was utilized to generate a 0.95 T magnetic field over a 4 × 20 × 15 cm3 volume. Within this volume, a high-resolution silicon diode array detector was positioned inside a PMMA phantom of 4 × 15 × 12 cm3 . This detector contains two orthogonal strips containing 505 sensitive volumes spaced at 0.2 mm apart. Proton beams collimated to a circle of 10 mm diameter with nominal energies of 90 MeV, 110 MeV, and 125 MeV were incident on the detector from an edge-on orientation. This allows for a measurement of the Bragg peak at 0.2 mm spatial resolution in both the depth and lateral profile directions. The impact of the magnetic field on the proton beams, that is, a small deflection was also investigated. A Geant4 Monte Carlo simulation was performed of the experimental setup to aid in interpretation of the results. Results: The nominal Bragg peak for each proton energy was successfully observed with a 0.2 mm spatial resolution in the 0.95 T transverse magnetic field in both a depth and lateral profiles. The proton beam deflection (at 0.95 T) was a consistent 2 ±0.5 mm at the center of the magnetic volume for each beam energy. However, a pristine Bragg peak was not observed for each energy. This was caused by the detector packaging having small air gaps between layers of the phantom material surrounding the diode array. These air gaps act to degrade the shape of the Bragg peak, and further to this, the nonwater equivalent silicon chip acts to separate the Bragg peak into multiple peaks depending on the proton path taken. Overall, a promising performance of the silicon detector array was observed, however, with a qualitative assessment rather than a robust quantitative dosimetric evaluation at this stage of development. Conclusions: For the first time, a high-resolution silicon-based radiation detector has been used to measure proton beam Bragg peak deflections in a phantom due to a strong magnetic field. Future efforts are required to optimize the detector packaging to strengthen the robustness of the dosimetric quantities obtained from the detector. Such high-resolution silicon diode arrays may be useful in future efforts in MRI-guided proton therapy research.

A Radiation Tolerant Proton Detector Based on MAPbBr3 single crystal

Radiation-Tolerant Proton Detector Based on the MAPbBr3 Single Crystal

Homologous Bromides Passivation of CH 3NH 3pbbr 3 Single Crystals for Photodetectors with Improved Properties

High Sensitivity X-Ray Detectors with Low Degradation Based on Deuterated Halide Perovskite Single Crystals

Research on the Fabrication and X‐Ray Detection Performance of MAPbBr3‐Based 3D/2D Heterojunctions

X‐Ray Irradiation Fluence‐Dependent Carrier Transport Capacity of MAPbBr3 Single Crystal

Suppression of Ionic and Electronic Conductivity by Multilayer Heterojunctions Passivation Toward Sensitive and Stable Perovskite X‐Ray Detectors

Real-time single-proton counting with transmissive perovskite nanocrystal scintillators

Kilogram-Scale Crystallogenesis of Halide Perovskites for Gamma-Rays Dose Rate Measurements

High-performance single crystal CH 3 NH 3 PbI 3 perovskite x-ray detector

Ultrasensitive and Robust CsPbBr3 Single-Crystal X-ray Detectors Based on Interface Engineering

Ultralow detection limit and high sensitivity X-ray detector of high-quality MAPbBr 3 perovskite single crystals

Perovskite single crystals with tin–lead gradient for improved ionization radiation detection

Controllable Growth of High Quality MAPbX 3 Perovskite Single Crystals for X-ray Detection

High-performance Single Crystal CH3NH3PbI3 Perovskite X-Ray Detector

Identification and Suppression of Point Defects in Bromide Perovskite Single Crystals Enabling Gamma-Ray Spectroscopy

Mechanical polishing with chemical passivation of perovskite single crystal for high-performance X-ray detector

Ultrasensitive and Robust 120 keV Hard X‐Ray Imaging Detector based on Mixed‐Halide Perovskite CsPbBr 3− n I n Single Crystals

Liquid-Phase Epitaxial Growth of Large-Area MAPbBr 3– n Cl n /CsPbBr 3 Perovskite Single-Crystal Heterojunction for Enhancing Sensitivity and Stability of X-ray Detector

First application of a high-resolution silicon detector for proton beam Bragg peak detection in a 0.95 T magnetic field

Solid-State Neutron Detection Based on Methylammonium Lead Bromide Perovskite Single Crystals