Abstract:This article presents a 915-MHz ultra-low-power (ULP) sub-sampling phase-tracking receiver (SSPT-RX). It is targeted for the power-constrained devices that need short range but medium high-speed data receiving, such as the multi-channel neural stimulator with arbitrary waveform generation. The zero-intermediate frequency (zero-IF) phase-tracking receiver (PT-RX) topology is adopted to simplify the sub-sampling RX architecture with direct demodulation of frequency-shift keying (FSK) signal while improving the image frequency issue. The frequency of local oscillator (LO) is reduced by ten times with the proposed architecture, which leads to greatly reduced power consumption. Fabricated in 65-nm CMOS process, the RX chip occupies an active area of 0.58 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> . The RX consumes one of the lowest power consumptions of 164 <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\mu \text{W}$ </tex-math></inline-formula> from 0.5-/1-V supplies. It achieves an energy efficiency of 32.8 pJ/bit at a data rate of 5 Mb/s, which is improved by <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\sim 5.6\times $ </tex-math></inline-formula> compared to the state-of-the-art RXs. The measured sensitivity of 915-MHz FSK signal receiving is −69.5 dBm with an LO frequency of 91.5 MHz, which is 1/10 of the carrier frequency. The achieved RX sensitivity figure-of-merit (FoM) is 174.3 dB.

A 0.8V, 152 μ W, 433 MHz Mixer-First Receiver with a Self-Adjusted Frequency Tracking Loop

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

20 . 6 A 0 . 6 V 32 . 5 mW Highly Integrated Receiver for 2 . 4 GHz ISM-Band Applications

A 60–90 GHz Mixer-First Receiver with Adaptive Temperature-Compensation Technique

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

An 89 Μw MICS/ISM Band Receiver for Ultra-Low-power Applications.

A 2.4 GHz 2.9 Mw Zigbee RF Receiver with Current-Reusing and Function-Reused Mixing Techniques

A 253- $\mu $ W 2.4-Ghz SAW-Less Mixer-First Uncertain-IF Receiver with Blocker Tolerant for Long-Distance Ultralow-Power IoT

A Low Power SAW-less 2.4-Ghz Receiver with an LC Matched Series N-path Filter.

Design of 1.8-mW PLL-Free 2.4-GHz Receiver Utilizing Temperature-Compensated FBAR Resonator

A Low-Power, Compact, 0.1–5.5-Ghz, 40-Dbm IB OIP3 LNTA-First Receiver for SDR

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A 1.65 Mw Direct-Conversion Receiver for UHF RFID Readers

An 8mw Ultra Low Power 60ghz Direct-Conversion Receiver with 55db Gain and 4.9db Noise Figure in 65nm CMOS

A 164-$\mu$ W 915-MHz Sub-Sampling Phase-Tracking Zero-IF Receiver With 5-Mb/s Data Rate for Short-Range Applications

2.4Ghz 20mb/s FSK Receiver Front-End and Transmitter Modulation PLL Design for Energy-Efficient Short-Range Communicaiton