Abstract:Polynitrogen (PN) deposited on multiwalled carbon nanotubes was synthesized by cyclic voltammetry with ultraviolet (UV) irradiation. Compared to the sample formed without UV, a larger amount of N8– was synthesized and was found to distribute more uniformly on the MWNTs with 254 nm UV irradiation, indicating that the production of more azide (N3)0 radicals as the precursors for synthesis of N8– by photoexcitation of azide (N3–) ions is a rate-limiting step for PN synthesis. An oxygen reduction reaction kinetics study indicated a four-electron reaction pathway on N8–, whereas a two-electron process occurs on N3–. Analysis by in situ shell-isolated nanoparticle-enhanced Raman spectroscopy revealed that the side-on and end-on O2 adsorption occurred at N8– and N3–, respectively, confirming the electron transfer process. A full direct-methanol fuel cell study shows that methanol crossover typically reduces the current density of Pt/C by ∼40% but has very little effect on the performance of the PN-MWNT catalyst after testing for 120 h. Moreover, the power density from the PN-MWNT cathode is at least twice that from a Pt/C cathode.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acscatal.1c03102.The experimental details of material synthesis, characterizations, electrochemical measurement, DMFC test, and DFT calculations, UV–visible absorption spectrum of the azide anion determined by TDDFT (Figure S1), CV curves of 12 cycles for different samples (Figures S2–S4), temperature profiles of the electrolyte during CV synthesis (Figures S5 and S6), LSV curves (Figure S7), Koutecky–Levich plots (Figure S8), NBO partial charge distribution on an N8– anion (Figure S9), and calculated vibrational frequencies and Raman activity for O2 split and *OOH adsorption (Tables S1 and S2) (PDF)This article has not yet been cited by other publications.

Polymerization of Potassium Azide in Liquid Nitrogen Using Nanosecond-Pulsed Spark Plasma

Pressure-induced polymerization of nitrogen in potassium azides

Polymerization of Nitrogen in Cesium Azide under Modest Pressure

A simple route to synthesize cubic gauche polymeric nitrogen

Charge transfer induced cubic gauche nitrogen from azides

All-Nitrogen Energetic Material Cubic Gauche Polynitrogen: Plasma Synthesis and Thermal Performance

Hexanitrogen (N6): A Synthetic Leap Towards Neutral Nitrogen Allotropes

Stabilization of hexazine rings in potassium polynitride at high pressure

Synthesis of C3N4+ by the Combination of Laser Ablation of Graphite and N2 Molecular Beam

Rational Synthesis of Polymeric Nitrogen N 8 – with Ultraviolet Irradiation and Its Oxygen Reduction Reaction Mechanism Study with In Situ Shell-Isolated Nanoparticle-Enhanced Raman Spectroscopy

Formation of the -N(no)n(no)- Polymer at High Pressure and Stabilization at Ambient Conditions

High-pressure and high-temperature induced polymerization of confined nitrogen

Observing C-N bond formation in plasma: a case study of benzene and dinitrogen coupling via an arylnitrenium ion intermediate

Novel Potassium Polynitrides at High Pressures

A facile route to synthesize cubic gauche polymeric nitrogen

Transformation of Ammonium Azide at High Pressure and Temperature

One-step Synthesis of Cubic Gauche Polymeric Nitrogen with High Yield Just by Heating

Production of Intense Atomic Nitrogen Beam Used for Doping and Synthesis of Nitride Film by Pulsed Laser Ablation

Free-standing cubic gauche nitrogen stable at 760 K under ambient pressure

Structural diversity of molecular nitrogen on approach to polymeric states

High-pressure synthesis of fully sp2-hybridized polymeric nitrogen layer in potassium supernitride