Abstract:Cryogenic pipeline chilldown is an inevitable process in cryogenic liquid transfer operation, but the researches on chilldown performance through a thick-wall tube are still insufficient. In the present study, a high-pressure cryogenic chilldown test platform is established to study the tube wall thickness influence on chilldown characteristics. Two stainless steel tubes, with 2 mm thickness wall and 5 mm thickness wall, respectively, are manufactured and tested under different inlet Reynolds numbers (Re) conditions. The temperature decrease curves and heat transfer variations are analyzed and compared. The test results show that a thicker wall tube requires an apparently longer chilldown time and a larger liquid consumption to reach the chilldown purpose. In the present experiments, the mass ratio of the two tubes is about 3.0, but the time cost ratio varies within 3.5–6.0 and the liquid consumption ratio is about 4.5. This performance indicates that in a thicker-wall pipe chilldown event, a lower efficient utilization of liquid cold energy could be speculated. Moreover, increasing inlet Re produces temperature rises both at critical heat flux (CHF) and Leidenfrost point (LFP). For the 2 mm wall tube cases, increasing inlet Re from Re = 5500 to Re = 43000 gives rise to a 39 K temperature rise in LFP and a 32 K temperature rise in CHF. Under the similar inlet Re variation, the temperature rises of LFP and CHF in the 5 mm wall tube cases are 28 K and 46 K, respectively. Comparatively, the 5 mm wall tube experiences a shorter transition boiling-dominated range when increasing the inlet Re. In addition, in the present test cases, the chilldown thermal efficiency varies with 8%–23%, and the 5 mm wall tube cases experience lower thermal efficiency than the 2 mm wall tube cases. To realize a high-efficient chilldown purpose, the approaches of increasing chilldown thermal efficiency should be significantly concerned in the chilldown scheme design, especially when a thick wall tube situation is encountered.

Experimental research and numerical simulation on cryogenic line chill-down process

Investigation on heat transfer in line chill-down process with various cryogenic fluids

Experiments and numerical simulation of dynamic cool-down process of stainless steel plate in liquid nitrogen bath

Experimental investigation on chill-down process of cryogenic flow line

Experimental investigation on line chill-down process by liquid argon

Experimental Investigation on Cryogenic Line Chill-Down Process by Using Liquid Nitrogen

Simulation and analysis of dynamic heat transfer inside a cryogenic valve under cryogenic test

Experimental investigation of line chill-down process with liquid oxygen

Experimental investigation on heat transfer characteristics in cryogenic chilldown of a helically coiled tube

An experimental study on terrestrial cryogenic tube chilldown II. Effect of flow direction with respect to gravity and new correlation set

Experimental investigations on transient cryogenic chilldown of a short horizontal copper transfer line

Investigation of quench flow boiling heat transfer correlations for liquid oxygen feed line chill-down with outlet contraction

Transient cryogenic chill down process in horizontal and inclined pipes

An experimental study on liquid nitrogen pipe chilldown and heat transfer with pulse flows

Predictions of Line Chilldown Boiling Regime Transitions by a Coupled CFD-Subgrid Boiling Model Validated against 1G LN2 Experiments

Simulations of Cryogenic Line Chilldown with Advanced Subgrid Wall Boiling Models

An experimental study on flow patterns and heat transfer characteristics during cryogenic chilldown in a vertical pipe

Two-Phase Flow and Heat Transfer During Chilldown of a Simulated Flexible Metal Hose Using Liquid Nitrogen

Experimental study on cryogenic chilldown performance through a thick-wall tube

Assessment of two-phase heat transfer coefficient and critical heat flux correlations for cryogenic flow boiling in pipe heating experiments

Transient modeling of cryogenic two-phase flow boiling during chill-down process