Abstract:A supercritical carbon dioxide (S-CO2) and Organic Rankine Cycle (ORC) combined cycle has been considered to fully use the residual heat of a high temperature heat source in this paper. The topping cycle is a S-CO2 recompression cycle, and the bottoming cycle is an ORC with R245fa as the working fluid. Compared with previous studies, the influence of several additional parameters, including the S-CO2 recompression cycle main compressor inlet temperature and pressure and the S-CO2 recompression cycle split ratio, has been conducted. It indicates that the split ratio plays an important role on the S-CO2 recompression cycle, even on the combined cycle. A thermodynamic optimization method which considers the split ratio is proposed to maximum the combined cycle thermal efficiency. By this method, more than 4.1% increment on the thermal efficiency can be attained. INTRODUCTION The supercritical carbon dioxide (S-CO2) is a special kind of CO2 fluid whose temperature and pressure are higher than its critical values (304.13K, 7.38 MPa). The S-CO2 cycle, which uses S-CO2 as the working fluid, is considered to be one of the most promising power generation technologies for the future (Feher, 1968). The S-CO2 cycle has higher efficiency and more compact system and components than conventional power cycles, especially in the high temperature range. Besides, CO2 is easy to obtain and the S-CO2 cycle system has high safety level. It is widely acknowledged that the S-CO2 cycle is applicable for various heat sources, such as the nuclear energy (Moisseytsev and Sienicki, 2009), concentrated solar power (Turchi and Ma, 2012), fuel cell (Xia et al., 2019) and waste heat recovery (Song et al., 2018a). One of the S-CO2 cycle characteristics is that the specific heat capacity of the cold side flow is much higher than that of the hot side in recuperators. For the S-CO2 recompression cycle, the CO2 flow is split to compensate for the specific heat difference in the low temperature recuperator and to further enhance the heat recuperation in the high temperature recuperator. Therefore, the residual heat is decreased and the S-CO2 recompression cycle has higher efficiency than simple recuperated cycle. The S-CO2 recompression cycle has been adopted by National Energy Technology Laboratory (NETL) of U.S. DOE for Supercritical Transformational Electric Power (STEP) program (Lambruschini et al., 2016).

Evaluation and optimization of supercritical cycles using CO 2 based mixtures as working fluids: A thermodynamic study

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Evaluation of the property methods for pure and mixture of CO2 for power cycles analysis

Computer-aided molecular design of CO 2 -based mixture working fluid harvesting engine waste heat

Thermodynamic Analysis and Optimization of a Supercritical Carbon Dioxide (S-CO2) Recompression Cycle Coupled with a Bottoming Organic Rankine Cycle

Thermo-economic analysis and multi-objective optimization of supercritical Brayton cycles with CO2-based mixtures

Thermodynamic analysis and parametric optimization of a novel S–CO2 power cycle for the waste heat recovery of internal combustion engines

Thermodynamic Performance Improvement of Recompression Brayton Cycle Utilizing CO2-C7H8 Binary Mixture

Exergetic, Economic and Exergo-Environmental Analysis of Bottoming Power Cycles Operating with CO2-Based Binary Mixture

Thermodynamic Analysis of Hybrid Two-Stage CO 2 Mechanical Compression–ejector Cooling Cycle

Performance improvement of supercritical carbon dioxide power cycles through its integration with bottoming heat recovery cycles and advanced heat exchanger design: A review

Dynamic performance analysis of transcritical power cycle with preheater and regenerator using CO 2 -based binary zeotropic mixtures

Investigation on the performance of the supercritical Brayton cycle with CO2-based binary mixture as working fluid for an energy transportation system of a nuclear reactor

CO2-based mixture working fluids used for the dry-cooling supercritical Brayton cycle: Thermodynamic evaluation

Thermoeconomic Analysis Of Optimization Potential For Co2 Vapor Compression Cycle: From Transcritical To Supercritical Operation For Waste Heat Recovery From The Steam Condenser

An adaptive CO 2 Brayton-Rankine power cycle for efficient utilization of low environment temperature: A thermodynamic analysis and optimization study

Optimal allocation of heat exchangers in a Supercritical carbon dioxide power cycle for waste heat recovery

Exergetic performance and comparative assessment of bottoming power cycles operating with carbon dioxide–based binary mixture as working fluid

Optimization of CO2 Transcritical Power Cycle (CTPC) for engine waste heat recovery based on split concept

Performance of supercritical Brayton cycle using CO2-based binary mixture at varying critical points for SFR applications

Supercritical CO2 Binary Mixtures for Recompression Brayton s-CO2 Power Cycles Coupled to Solar Thermal Energy Plants