Abstract:The use of a binary cycle coupled to the complete reinjection of non-condensable gases could provide a valid answer to the improvement of the sustainability of geothermal plants. In recent years, the interest in the use of CO2 as a working fluid in transcritical cycles has increased. However, the low critical temperature of carbon dioxide (≈30 °C) requires the cooling cycle, temperatures below 15 °C, which are not always available. In this work, to overcome this limitation and obtain a higher critical temperature and a lower maximum pressure for more flexible applications of transcritical binary cycles, the possibility of using a second component, mixed with CO2, has been evaluated. For this purpose, the following fluids have been proposed: R1234yf, R1234ze(E), n-butane, n-hexane, n-pentane, and propane, with a minimum considered carbon dioxide molar content of 60%. To carry out a cycle analysis, the knowledge of the thermodynamic properties of CO2-mixtures is fundamental; however, suitable equations of state under the appropriate conditions for these blends have not been clearly defined yet. Therefore, in the first part of this paper, different EoS for predicting thermodynamic properties of pure CO2 and CO2-based mixtures are analyzed and compared with reference data obtained from works published in the literature. However, because of the lack of experimental data of the selected blends, the values of density, enthalpy and entropy, obtained with the selected EoS, are compared with NIST REFPROP results. The EoS involved in the evaluation are cubic-type (PR, PR-Twu, PRSV, RK, SRK, GCEOS), Virial-type (LKP, BWRS), Helmholtz-type (SW), and SAFT-type (PC-SAFT). In a power cycle, the fluid works under different conditions, involving several possible states across the components. So the influence of the different EoS on each power cycle's key component for pure CO2 and two selected CO2-based mixtures has been investigated. The thermodynamic results show that the CO2-based mixtures, in a transcritical configuration, can achieve efficiencies higher than the sCO2 power cycle.

CO2-based mixture working fluids used for the dry-cooling supercritical Brayton cycle: Thermodynamic evaluation

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Experimental and Numerical Study on Thermal Hydraulic Performance of Trapezoidal Printed Circuit Heat Exchanger for Supercritical CO2 Brayton Cycle

Performance Evaluation of a Direct Air-Cooled Supercritical Recompression Brayton Cycle Using CO2/n-Butane As the Working Fluid Operating under Off-Design Conditions

Investigation on the performance of the supercritical Brayton cycle with CO2-based binary mixture as working fluid for an energy transportation system of a nuclear reactor

Supercritical CO2 Binary Mixtures for Recompression Brayton s-CO2 Power Cycles Coupled to Solar Thermal Energy Plants

Supercritical CO2 mixture Brayton cycle with floating critical points for concentrating solar power application: Concept and thermodynamic analysis

New Knowledge on the Performance of Supercritical Brayton Cycle with CO2-Based Mixtures

Assessment of Ternary CO2 Mixtures As Working Fluids in Supercritical Brayton Cycles with Floating Critical Points

Thermo-economic analysis and multi-objective optimization of supercritical Brayton cycles with CO2-based mixtures

Thermodynamic analysis of CO2-SF6 mixture working fluid supercritical Brayton cycle used for solar power plants

Thermodynamic Analysis for Supercritical Carbon Dioxide Brayton Cycle by Considering Both Thermal Efficiency and Cooler Area

Performance of supercritical Brayton cycle using CO2-based binary mixture at varying critical points for SFR applications

Thermodynamic analysis of supercritical Brayton cycles using CO2-based binary mixtures for solar power tower system application

Thermodynamic Analysis of Brayton Cycles Using Supercritical Carbon Dioxide and its Mixture as Working Fluid

Selecting Dry Cooling System for Supercritical Carbon Dioxide Brayton Cycle: Thermoeconomic Analysis

Off-design Performance Analysis of Supercritical CO2 Mixture Brayton Cycle with Floating Critical Points

Molecular Dynamics Study on Viscosity Coefficient of Working Fluid in Supercritical CO2 Brayton Cycle: Effect of Trace Gas

Evaluation of the property methods for pure and mixture of CO2 for power cycles analysis

Thermodynamic evaluation and optimization of supercritical CO 2 Brayton cycle considering recuperator types and designs

Performance Analysis and Comparison Study of Transcritical Power Cycles Using Co2-Based Mixtures As Working Fluids