Abstract:The use of a binary cycle coupled to the complete reinjection of non-condensable gases could provide a valid answer to the improvement of the sustainability of geothermal plants. In recent years, the interest in the use of CO2 as a working fluid in transcritical cycles has increased. However, the low critical temperature of carbon dioxide (≈30 °C) requires the cooling cycle, temperatures below 15 °C, which are not always available. In this work, to overcome this limitation and obtain a higher critical temperature and a lower maximum pressure for more flexible applications of transcritical binary cycles, the possibility of using a second component, mixed with CO2, has been evaluated. For this purpose, the following fluids have been proposed: R1234yf, R1234ze(E), n-butane, n-hexane, n-pentane, and propane, with a minimum considered carbon dioxide molar content of 60%. To carry out a cycle analysis, the knowledge of the thermodynamic properties of CO2-mixtures is fundamental; however, suitable equations of state under the appropriate conditions for these blends have not been clearly defined yet. Therefore, in the first part of this paper, different EoS for predicting thermodynamic properties of pure CO2 and CO2-based mixtures are analyzed and compared with reference data obtained from works published in the literature. However, because of the lack of experimental data of the selected blends, the values of density, enthalpy and entropy, obtained with the selected EoS, are compared with NIST REFPROP results. The EoS involved in the evaluation are cubic-type (PR, PR-Twu, PRSV, RK, SRK, GCEOS), Virial-type (LKP, BWRS), Helmholtz-type (SW), and SAFT-type (PC-SAFT). In a power cycle, the fluid works under different conditions, involving several possible states across the components. So the influence of the different EoS on each power cycle's key component for pure CO2 and two selected CO2-based mixtures has been investigated. The thermodynamic results show that the CO2-based mixtures, in a transcritical configuration, can achieve efficiencies higher than the sCO2 power cycle.

Exergetic performance and comparative assessment of bottoming power cycles operating with carbon dioxide–based binary mixture as working fluid

Exergetic, Economic and Exergo-Environmental Analysis of Bottoming Power Cycles Operating with CO2-Based Binary Mixture

Thermodynamic Performance Improvement of Recompression Brayton Cycle Utilizing CO2-C7H8 Binary Mixture

Evaluation and optimization of supercritical cycles using CO 2 based mixtures as working fluids: A thermodynamic study

Parameters Analysis and Techno-Economic Comparison of Various ORCs and Sco2 Cycles As the Power Cycle of Lead–Bismuth Molten Nuclear Micro-Reactor

Performance Evaluation of CO2 + SiCl4 Binary Mixture in Recompression Brayton Cycle for Warm Climates

A comparative study of the energy, exergetic and thermo-economic performance of a novelty combined Brayton S-CO2-ORC configurations as bottoming cycles

Investigation on the performance of the supercritical Brayton cycle with CO2-based binary mixture as working fluid for an energy transportation system of a nuclear reactor

Dynamic performance of the transcritical power cycle using CO2-based binary zeotropic mixtures for truck engine waste heat recovery

Dynamic performance analysis of transcritical power cycle with preheater and regenerator using CO 2 -based binary zeotropic mixtures

On mixtures as working fluids of air-cooled ORC bottoming power plants of gas turbines

Evaluation of the property methods for pure and mixture of CO2 for power cycles analysis

CO2-based mixture working fluids used for the dry-cooling supercritical Brayton cycle: Thermodynamic evaluation

Thermodynamic optimization of Rankine cycle using CO2-based binary zeotropic mixture for ocean thermal energy conversion

Proposal and Thermodynamic Assessment of S-CO2 Brayton Cycle Layout for Improved Heat Recovery

Performance improvement of supercritical carbon dioxide power cycles through its integration with bottoming heat recovery cycles and advanced heat exchanger design: A review

Advancements in Supercritical Carbon Dioxide Brayton Cycle for Marine Propulsion and Waste Heat Recovery

An adaptive CO 2 Brayton-Rankine power cycle for efficient utilization of low environment temperature: A thermodynamic analysis and optimization study

Thermo-economic analysis and multi-objective optimization of supercritical Brayton cycles with CO2-based mixtures

Performance analysis and parametric optimization of supercritical carbon dioxide (S-CO 2 ) cycle with bottoming Organic Rankine Cycle (ORC)

Exploration and Analysis of CO2 + Hydrocarbons Mixtures As Working Fluids for Trans-critical ORC