Abstract:Introduction. The technological process of restoring a part should provide more than 80% of the resource and no more than 50% of the cost of a new part. The wear resistance of the applied coating determines the resource of the restored part operating under waterjet and boundary friction. The microhardness of an iron-based electrolytic coating is one of the key indicators of wear resistance. The study of the results of statistical processing and the factors most affecting the increase in the microhardness of the iron-based coating will make it possible to recommend and optimize the deposition conditions for obtaining the most wear-resistant coatings. Materials and methods. The studies on equipment that let to obtain the necessary data with the required accuracy were carried out. The mathematical processing using modern statistical data processing tools that excluded possible errors, let to obtain the dependence of factors with the necessary accuracy was carried out. Results . During the study of the developed sulfate-chloride electrolyte for the deposition of an iron–chromium coating, it became necessary to determine the effect of deposition conditions – ‘factors’ (temperature, acidity of the electrolyte, cathode current density) on the microhardness of the coating – ‘response’. It was found that the combination of the factors ‘temperature’ and ‘cathode current density’ in the coded values of 1.5. 2.0 and -2 are the most significant. The deposition conditions in order to obtain a coating with maximum microhardness are optimized. Discussion and conclusions. As a result of the conducted studies for the effect of the deposition conditions of the Fe-Cr alloy from the sulfate-chloride electrolyte on the microhardness of the coating, it was found that in order to obtain high-quality coatings of the iron-chromium alloy with high microhardness, it is necessary to strictly comply with the requirements of the deposition conditions and acidity to a greater extent. As the current density and temperature of the electrolyte, compared with the acidity of the electrolyte, iron baths are installed and regulated by equipment.

The effect of hard chrome plating on iron fines formation

Effect of Process Parameters on Microstructure and Properties of AlCoCrFeNi-WC-WS2 Composite Coating Prepared by Laser Cladding

Effect of hard chrome plating parameters on the wear resistance of low carbon steel

Dry sliding wear behavior of hard-chrome and zinc-phosphate conversion coatings on steel substrates

Effect and performance analysis of different surface treatments on polymer-metal friction pairs

Engineering Properties of Chromium Plating and Electroless and Electroplated Nickel

Microstructure, mechanical and erosion wear analysis of post heat treated iron alloy based coating with varying chromium

Tribological Study of Thin-Electroplated Chromium: Evaluation of Wear Rate as a Function of Surface Roughness

The Wear Resistance of an Ni-Cu-P Brush Plating Layer on Different Substrates

Experimental Research on Hard and Crack-Free Electrodeposited Chromium Coatings

Effect of Chromium on Microstructure and Wear Resistance of Fe-Cr-C Hardfacing Alloys

Effect of Surface Melting and Chromium Surface Alloying on Wear Behavior of Ductile Iron

EFFECTS OF Cr PLATING LAYER ON SHEAR STRENGTH AND INTERFACE BONDING CHARACTERISTICS OF MILD STEEL/CFRP JOINT BY LASER HEATING

Enhancing the adhesion strength and wear resistance of nanostructured NiCrN coatings

Wear Behaviour of Hard Chrome and Tungsten Carbide-HVOF Coatings

The Effect of Various Surface Treatments in Cleaning and Preparing Copper, Nickel and Steel for Chromium Plating

Effect of Hot-Rolling Deformation on Microstructure and Sliding Wear of High-Chromium Cast Iron

A Study On The Dynamic Characteristics Of Abrasion For High-Chromium Alloys

Surface Topological Investigation of Seal Bushing by Using Chromium Plating Process

The investigation of support effect from hard substrate to soft coating of PI/EP-PTFE under different coating thicknesses and frictional contacts

Electrolytic coating of iron-chromium alloy of sulphate-chloride electrolyte in machine parts recovery process modelling