Abstract:316 stainless steel (SS) was coated with CoCrFeNiNbx (x: atomic ratio, x = 0, 0.1, 0.2, and 0.3) high entropy alloy coatings (HEACs) by laser cladding (LC). The impacts of Nb content on the phase composition, microstructure, microhardness, wear resistance and corrosion properties of CoCrFeNi based HEACs were examined. Different from the canonical dendritic (DR) - interdendritic (ID) microstructure presented by the other three HEACs, the ID of Nb0.3 HEACs also existed nanoscale Nb-rich Laves phase composed of Nb-Ni and Nb-Co. The inclusion of Nb significantly reduced the average grain size of CoCrFeNi based HEACs from 59.43 mu m to 11.38 mu m. It also greatly diminished the formation of high angle grain boundaries (HAGBs), increasing the percentage of low angle grain boundaries (LAGBs) from 31 % to 61 %. The microhardness of Nb-containing HEACs was significantly promoted due to the solid solution strengthening and fine grain strengthening caused by large size Nb atoms. Affected by Laves phase with high coordination number and space filling ratio and higher proportion of LAGBs, the microhardness of Nb0.3 HEAC was even as high as 530 HV. The increase in Nb concentration also strengthened the HEACs' resistance to wear. Nb0, Nb0.1, Nb0.2, and Nb0.3 HEACs had corresponding specific wear rates of 0.36, 0.32, 0.23, and 0.20 mm3/Nm. Unlike 316 SS, Nb0 and Nb0.1 HEACs, which had both adhesive wear and abrasive wear, Nb0.2 and Nb0.3 HEACs were mainly wear by abrasive wear. The corrosion behavior of CoCrFeNiNbx HEACs in 0.5 M H2SO4 solution was similar to 316 SS, but the corrosion resistance was stronger than 316 SS. Nb0.3 HEAC with the Ecorr of -164 mV and Icorr of 6.40 x 10-7 A/cm2 showed the best acid corrosion resistance, which could be attributed to the stable and dense passivation film on its surface. Distinct from the intergranular corrosion of other coatings, the corrosion of Nb0.3 HEAC mainly occurred in DR, because the FCC phase acted as the anode site in it when FCC and Laves phase co-existed.

Engineering Properties of Chromium Plating and Electroless and Electroplated Nickel

Electrochemical Corrosion Behavior in Sulfuric Acid Solution and Dry Sliding Friction and Wear Properties of Laser-Cladded CoCrFeNiNb High Entropy Alloy Coatings

Fabrication and performance of Ni-Co-P/Si3N4 electroplated composite coatings on al-si alloys

Dry sliding wear behavior of hard-chrome and zinc-phosphate conversion coatings on steel substrates

Comparison to Micro Wear Mechanism of PVD Chromium Coatings and Electroplated Hard Chromium

Wear and Corrosion Properties of Crystalline Ni-W Alloy Coatings Prepared by Electrodeposition

Effect of hard chrome plating parameters on the wear resistance of low carbon steel

Comparative Study of Thermally Sprayed Coatings Under Different Types of Wear Conditions for Hard Chromium Replacement

Tribological Study of Thin-Electroplated Chromium: Evaluation of Wear Rate as a Function of Surface Roughness

Wear Behaviour of Hard Chrome and Tungsten Carbide-HVOF Coatings

Mechanical properties of Ni-based coatings fabricated by electroless plating method

Mechanical properties of hard chromium tungsten nitride coatings

Comparative Micro-Scale Abrasive Wear Testing of Thermally Sprayed and Hard Chromium Coatings

Wear behaviour and microstructural characteristics of cold sprayed nickel-alumina coatings on boiler steel

Wear behavior of graded nickel-phosphorus coatings with a medium phosphorus top layer: An experimental and molecular dynamics simulation study

An Evaluation of the Wear Resistance of Electroplated Nickel Coatings Composited with 2,2,6,6-tetramethylpiperidine 1-oxyl-Oxidized Cellulose Nanofibers

Studies of high temperature sliding wear of medium carbon Nickel-Chromium based alloy steel

Microstructure and wear properties of crystalline W alloy coatings prepared by electrodeposition

Analysis of thin film electrochemical deposition process diffused by carbon tool steels

The Wear Resistance of an Ni-Cu-P Brush Plating Layer on Different Substrates

Mechanical Properties and Tribological Behaviour of Electroless Ni–P–Cu Coatings on Corrosion-Resistant Alloys under Ultrahigh Contact Stress with Sprayed Nanoparticles