Abstract:Due to the existence of an acid etch resistant thin amorphous silicon layer over the smooth grooves of the diamond wire sawing polycrystalline silicon wafer surface, the anti-reflection effect is usually not ideal using the mature acidic texturization. The amorphous silicon layer will be produced on the machined surface by material ductile removal. Therefore, during the process of cutting photovoltaic polycrystalline silicon wafers, the material removed in the brittle way is expected and the surface topography of the wafers formed with the brittle fracture is better for the texture fabricating. In this paper, a mathematical model considering the influences of process parameters and wire saw parameters was developed based on indentation fracture mechanics. The variations of cutting groove profile formed by different material removal modes were also included. The effect of abrasives distributed on the wire saw on material removal and surface formation of polysilicon was analyzed. The results showed that most of abrasives removed material with ductile removal mode, however, the volume of the material removed by abrasive in ductile mode is less than 10% of the total removal volume. Brittle fracture removal mode was still the major way of material removal in diamond wire sawing. With the same ratio of the feed rate and wire speed, the faster feed rate and wire speed will not only improve the cutting efficiency, but also is easier to obtain a brittle fracture surface. There is a critical angle θ c for the distribution of abrasives on the wire saw surface. Only when the position angle of the abrasive removing material in brittle mode is less than θ c , the brittle fracture can be formed on the wafers surface.

Surface damage and metal-catalyzed chemical etching investigation of multicrystalline silicon by diamond wire sawing

A Metal-Free Additive Texturization Method Used for Diamond-Wire-sawn Multi-Crystalline Silicon Wafers

Effect of Additives on Making Texture Surface on Multicrystalline Silicon Wafer by Diamond Wire Sawing

Constructing Submicron Textures on Mc-Si Solar Cells Via Copper-Catalyzed Chemical Etching

An Innovative Light Trapping Structure Fabrication Method on Diamond-Wire-Sawing Multi-Crystalline Silicon Wafers

Versatile Strategies for Improving the Performance of Diamond Wire Sawn Mc-Si Solar Cells

Cu-assisted Chemical Etching of Diamond Wire Sawn Multicrystalline Silicon Wafers for Texturing

Surface formation, morphology, integrity and wire marks in diamond wire slicing of mono-crystalline silicon in the photovoltaic industry

Recent Advances in Precision Diamond Wire Sawing Monocrystalline Silicon

High-Efficient Solar Cells Textured by Cu/Ag-Cocatalyzed Chemical Etching on Diamond Wire Sawing Multicrystalline Silicon

Evaluation of Fixed Abrasive Diamond Wire Sawing Induced Subsurface Damage of Solar Silicon Wafers

INFLUENCE OF SUB-SURFACE DAMAGE ON TEXTURING OF MONOCRYSTALLINE SILICON WAFERS FOR SOLAR CELLS

The effect of cut depth and distribution for abrasives on wafer surface morphology in diamond wire sawing of PV polycrystalline silicon

Improvement of conversion efficiency of multicrystalline silicon solar cells by incorporating reactive ion etching texturing

Experiment study on electroplated diamond wire saw slicing single-crystal silicon

A Microscopic Tem Study Of The Defect Layers In Cast-Mono Crystalline Silicon Wafers Induced By Diamond-Wire Sawing

One-step Cu-assisted chemical etching at room temperature of inverted pyramid array for high-performance crystalline silicon solar cells

Study on surface integrity and ductile cutting of PV polycrystalline silicon and wear mechanisms of electroplated diamond wire

Thin Czochralski silicon solar cells based on diamond wire sawing technology

Metal-catalyzed chemical etching using DIO3 as a hole injection agent for efficient submicron-textured multicrystalline silicon solar cells

Research on Silicon Wafer Surface Phase under the Ultra-thin Slicing Process and Its Etching Hindrance Behavior during Metal-Assisted Chemical Etching