Abstract:Application of poly-aluminum chloride (PACl) coagulant is a popular mode of water treatment worldwide because of the high capacity of PACl to neutralize charge. The manufacture and use of PACls with various basicities in different regions around the world suggest that the characteristics of the raw water are important determinants of the efficacy of PACl application. However, attention has not been fully paid to the effects of water quality other than the substances to be removed. In this study, two typical PACls with different basicities were used to investigate why the performance of PACls depends on the characteristics of the raw water. We focused on the concentrations of inorganic ions in the raw water. Use of high-basicity PACl (HB-PACl) with a high content of polymeric-colloidal species (Alb+Alc) resulted in very slow floc formation and little turbidity removal in raw water with low concentrations of sulfate ions. The performance of the HB-PACl was inferior to that of normal-basicity PACl (NB-PACl), although the charge-neutralization capacity of the HB-PACl was higher. Rates of floc formation were strongly correlated with the rate of aluminum precipitation by hydrolysis reaction, which was identified as an indicator for evaluating the compatibility of raw water with PACl treatment. Among the common ions in natural water, the sulfate ion had the greatest ability to hydrolyze and precipitate PACl because of its divalency and tetrahedral structure. This conclusion followed from experimental results showing similar effects for selenate and chromate ions as for sulfate ions and somewhat smaller effects for thiosulfate ions. Bicarbonate ions and natural organic matter affected PACl hydrolysis-precipitation, but chloride ions, nitrate ions, and cations had little effect on PACl hydrolysis-precipitation. Interestingly, the abilities of sulfate ions to hydrolyze HB-PACl and NB-PACl were very similar, but bicarbonate ions were less effective in hydrolyzing HB-PACl than NB-PACl, and bicarbonate ions contributed little to the hydrolysis-precipitation of HB-PACl in raw water with normal alkalinity. Therefore, sufficient coagulation with HB-PACl therefore usually requires a certain concentration of sulfate ions in water to be treated. The implication is that which anions are most influential to the hydrolysis-precipitation of PACl, and thus to PACl's coagulation ability depends on the constituents of the PACl.

Estimating of optimal dose of PACL for turbidity removing from water

Modeling and optimization of the coagulation/flocculation process in turbidity removal from water using poly aluminum chloride and rice starch as a natural coagulant aid

Application of a green coagulant with PACl in efficient purification of turbid water and its mechanism study

Overlooked effect of ordinary inorganic ions on polyaluminum-chloride coagulation treatment

Effect of Polyaluminum Chloride on Enhanced Softening for the Typical Organic-Polluted High Hardness North-China Surface Waters

Removal of Perfluorooctanoate from Surface Water by Polyaluminium Chloride Coagulation

Preparation and characterization of coagulation/flocculation behavior of a novel inorganic–organic hybrid polymer for reactive and disperse dyes removal

Organic and Inorganic Matter Removal Using High Polymeric Al13 Containing Polyaluminium Chloride

Optimization of pre-oxidation enhanced coagulation for micro-polluted water treatment by response surface method

Synthesis of Polyaluminum Chloride Coagulant from Waste Aluminum Foil and Utilization in Petroleum Wastewater Treatment

Optimization of polypropylene microplastics removal using conventional coagulants in drinking water treatment plants via response surface methodology

Effect of pH on the Turbidity Removal of Wastewater

Experimental Study on Application of PAC Produced Electrochemically in Water and Wastewater Treatment

Novel method of poly aluminum chloride extraction from kaolin and its application for wastewater treatment

[Removal of Turbidity and Effect of Humic Acid in Flocculation by Polyferric Chloride].

Preparation and Characterization of Polyaluminum Chloride Containing High Content of Al-13 and Active Chlorine

Response of sediment microbial communities to different levels of PAC contamination and exposure time

Removal of heavy metals by conventional water treatment plants using poly aluminum chloride

onventional water treatment plant for the minimization of new emerging pollutants in drinking water sources : process optimization using response surface methodology †

Development of a Polyaluminum Ferric Titanium Chloride for Phosphorous Removal in Water

Enhanced Coagulation with Polyaluminum Chlorides: Role of Ph/alkalinity and Speciation.