Optimization of pre-oxidation enhanced coagulation for micro-polluted water treatment by response surface method

Zhou, R.
DOI: https://doi.org/10.1007/s13762-024-05948-3
2024-09-08
International Journal of Environmental Science and Technology
Abstract:Taking the natural water in Anhui Polytechnic University as the research object, the removal of micro-pollutants in water body by KMnO 4 pre-oxidation enhanced polyaluminium chloride (PAC) coagulation process was studied. Firstly, the ability of different experimental schemes to remove turbidity, TP (Total Phosphorus) and UV 254 was investigated to determine the pre-oxidation scheme. Then, on the basis of the selected pre-oxidation scheme, the effects of the dosage of KMnO 4 , dosage of PAC, pre-oxidation time and pH on the removal of pollutants were investigated. Taking removal rate of turbidity, UV 254 and TP as the response values, the response surface method (RSM) was used to investigate the independent and interactive effects of the dosage of KMnO 4 (A), PAC dosage (B) and pre-oxidation time (C). The technological parameters of KMnO 4 pre-oxidation enhanced coagulation treatment of micro-polluted water were optimized. The results showed that adding KMnO 4 for 5 min followed by adding PAC had the best treatment effect. The influence order is as follows: turbidity (B > A > C), UV 254 (B > C > A), TP (A > B > C). The optimal technology parameters predicted by the model are as follows: A is 0.886 mg/L, B is 47.498 mg/L, and C is 13.1 min. Under these conditions, the best removal rates of turbidity, TP and UV 254 were 92.43%, 86.25% and 40.6%, respectively, and the validated values were 92.51%, 88.67% and 41.32%, respectively. The deviation values from the model prediction are 0.07%, 2.42% and 0.72%.
environmental sciences
What problem does this paper attempt to address?