Niobium doping of CVD-WS 2 monolayers using solid precursors with and without salt-KBr as a catalyst: A comparative study

Neileth Stand,André N. Barbosa,Pablo R.A. de Oliveira,Cesar D. Mendoza,F.L. Freire
DOI: https://doi.org/10.1016/j.apsusc.2024.159816
IF: 6.7
2024-03-06
Applied Surface Science
Abstract:The in situ doping of tungsten disulfide (WS 2 ) monolayers with Niobium (Nb) atoms was obtained through the atmospheric pressure chemical vapor deposition (APCVD) method by controlling the Nb 2 O 5 and WO 3 precursors mass ratios. Samples were prepared employing the same growth parameters with and without the use of KBr salt as a catalyst. In both cases, the Nb incorporation quenches the luminescence intensity of the doped samples, and it depends on the Nb 2 O 5 :WO 3 mass ratio. X-ray photoelectron spectroscopy (XPS) measurements were performed, and the observed redshift at the Fermi level indicated p-type doping. Nb-doped WS 2 monolayers synthesized without the use of the catalyst have lower defect density, as revealed by a careful Raman analysis, and are free of agglomerates on their monolayers' basal plane. The use of KBr as the catalyst increases the average crystal size but also increases the disorder effects compared with samples prepared without the use of salt. The presence of agglomerates of impurities at the surface of doped samples was observed in samples prepared with the use of salt as a catalyst. The controlled synthesis of p-type WS 2 with low defect density is essential for developing electronic and photonic devices based on WS 2 material.
chemistry, physical,physics, applied, condensed matter,materials science, coatings & films
What problem does this paper attempt to address?